Question about Minn Kota 55 AutoPilot Universal Sonar Combo GPS Receiver

1 Answer

My motor just quit working all of a sudden. I tracked down the electrical and I found there was power going into the control board but none coming out to the motor. I am assuming the board is bad. This motor is the powerdrive with the remote. It is 2 to 3 years old (HELP)

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 508 Answers

Call minkota support!!!

Posted on Jun 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Nordic Track C2255 no power to the console and the fan is running unable to turn of the fan, checked all the wires on the control board and the LED is fixed red.

This is a situation the controller board motor is Faulty.
They controlled the console CPU BOARD. with 8-12VdC
For CMOS Circuit.,this board has 3 control power supply Some IGTB is faulty: 1) Main motor 2) Elevation motor 3) Console Control
HOwever tight the connector coming from controller board motor to the Console very well, and clean it.
Otherwise replace the Controller board motor.

Nov 17, 2017 | Nordic Track Exercise & Fitness

1 Answer

What can i do to determine cause for parking lights. tailights and interior lights to suddenly quit working?

Do the fuses have power when the switch is turned on ?
Do you have power coming out of the switch for each circuit ?

Aug 25, 2014 | Cars & Trucks

1 Answer


There would seem to be a problem with your control board bypassing control selections............service technician required for repairs to this problem.

Nov 12, 2013 | Frigidaire Electric Dryer

1 Answer

2001 tahoe power window will not go down, motor is working

Door panel will come of and on fairly simple look for covers that pop off to give access to retaining screws,probably has broken window regulator.

Jun 17, 2009 | 2001 Chevrolet Tahoe

1 Answer

Trunk pull Down Motor Suddenly stopped working

did it quit making the noise when you lightly push down on the trunk? most people slam these trunks and your not suppose to you are only to put light pressure on them and they pull it closed theirself.. you might check your relays under the hood and look in the box lid to see which one it is.. if this is not the problem you might have to replace the motor to the latch .. you might check with a test light to see if there is power to the motor first though .. thanks and holler if you have more Jerry .

Apr 23, 2009 | 2004 Lincoln Town Car

1 Answer

Buttons on the TV Display quit working

The control circuit board assembly most likely has to be replaced, or the circuit board that has the control circuits has to be replaced.

The only basic thing you can do is open the set and look for any loose connections. Beyond that, there is nothing you can do yourself.

Many times when cleaning the screen people tend to use too much liquid cleaner and they get drops of liquid in to the set through the lip of the bezel. This will usually cause damage to any electronic areas that the liquid comes in to contact with.

Take care, these sets can be fairly expensive to service.

Jerry G.

Feb 10, 2009 | Olevia LT37HVS 37 in. LCD HDTV

1 Answer

Won't shut off!!

there is a control board under the glass where you touch to make it come on. some models were recalled. it you contact thermador they should come and take care of it for you

Nov 25, 2007 | Thermador 37 in. CET365 Electric Cooktop

1 Answer

Surface units working, oven is not. clock panel is blank.

Sounds like your going to have to replace the control board. Sometimes after a power failure there's a surge when the electric comes on and this can fry a control board.

May 02, 2007 | GE Profile Spectra JGBP90 Gas Kitchen...

Not finding what you are looking for?
GPS Logo

Related Topics:

380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Minn Kota GPS Experts


Level 3 Expert

81400 Answers

Will Halftowaite

Level 3 Expert

508 Answers

The Knight
The Knight

Level 3 Expert

75774 Answers

Are you a Minn Kota GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides