Question about Graco Pack 'n Play

1 Answer

How do i get the sides to lock and stay up? - Graco Pack 'n Play

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 125 Answers

You have to turn and pull the center a little bit then find the straight position of each of the locks. remember they got both sides and then push down slightly.
it's treaky and coming back blocked very fast. you have to manage(with help like I had:D) all of them at the same time
Good luck.
Let me know if I helped

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Safe won't stay locked, key missing but have key pad.


You might need to have the key set to lock in order to use the keypad or check the battery in side the door

Mar 08, 2013 | Locks & Locksmithing

1 Answer

My 2006 g35x won't stay locked the unlock botton


check for a short or a bad wire sounds like a bad conection check your conections

Aug 12, 2012 | Cars & Trucks

1 Answer

Although I lock my doors, the unlock by themselves after a short (approximately 40 second) time. The alarm stays on however.


Sounds like the central locking system thinks a door is open, check the bonnet and tailgate switches are indeed closing (and sunroof if fitted) make sure the boot light is not staying on. Try locking it from the passenger side door lock key cylinder instead of the drivers side or the remote and see if it is ok then

Nov 05, 2010 | 2005 Toyota Matrix

1 Answer

Duet GHW9150P Front Load Washer: control locked light stays on ,wont let you do any...


Press and hold "end of cycle" button for 3 seconds, on the right side of panel. This is the child lock feature, do it again & it locks.

If helped, pl rate me good!!

May 13, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Front Driver's side door won't stay locked


It sounds like your lock actuator is dead....ya need to replace the lock actuator.

Aug 29, 2009 | 2004 Kia Optima

1 Answer

Cant get back door to stay closed . The lock is stuck in locked position I think and the door is open. When I go to close it, it is'nt staying closed. Had to duck tape it to stay closed. LOL! I keep...


It sounds to me ( correct me if I'm wrong ) like the door latch on the side vertical edge of the door is in the LOCKED POSITION. In order to unlock it perform the following. First electrically with the LOCK button UNLOCK the locks. Now with one hand hold the OUTSIDE DOOR HANDLE IN THE OPEN POSITION, while at the same time FLIPPING OPEN THE LATCH. All Done . Now you can close the door. Hope this helps

Jun 27, 2009 | 1997 Chevrolet Lumina

1 Answer

1998 Ford Windstar fuse problem - dome light stays on etc


you most likely have a bad door ajar switch- the door panel has to be removed to access it, its on the door latch- you can unplug them this will take care of the batt drain prob.as for the locks it may be a switch problem- most ford vehicles will not let you lock the vehicle from the driver's door when it's open to prevent locking the keys in.

May 26, 2009 | 1998 Ford Windstar

1 Answer

Winnie the pooh travel cot from mothercare. cant get the sides to stay locked, they keep folding down when pushed to check if they are stable. need instructions. don't know actual name of product, but it...


hi there yes you need to pull the middle handle right up almost halfway high as cot then flip sides out they will automatically lock then close the handle x

May 09, 2009 | Baby Gear

1 Answer

Trying to open my combi playpen


lock the side rails up first thing before you do anything else. make sure the bottom is all the way up, then lock sides spread feet apart and push down in center

Apr 10, 2009 | Baby Gear

1 Answer

When i lock or unlock my car the drivers side indicator stays contantly on


There is a Volvo service bulletin on this as a problem. You should have your dealer fix this under the conditions of the Technical Service Bulletin that they they have for this. The service may be free.

May 26, 2008 | 2000 Volvo V40

Not finding what you are looking for?
Graco Pack 'n Play Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Graco Toys Experts

Shehu Pro
Shehu Pro

Level 3 Expert

1284 Answers

ray gallant

Level 3 Expert

43014 Answers

thegtw

Level 2 Expert

55 Answers

Are you a Graco Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...