Need legs for plasma to stand on unit hyunddai hpt 420

Since its a Plasma or seems to be you got this in the wrong area-a glitch on the site here often does this---if a flat screen set--Plasma or LCD post the question with model number in the text under Flat screen Televisions so a expert can assist you.

probably a bad VX or VY card.

If your TV is under warranty... call samsung for solution

if its like my p50dhm just remove 6-8(each leg) screws on back located at legs of stand pretty obvious....stand will try to hang-up plus must come off equal on each side or will bind

Did you ever find the legs/table stand for this TV? I'm looking for the same.

Try a computer/electronics store. Ask for a power cable for an lcd monitor. It should be the cable you need.

If you are using the stock leg's.

I have the same model, there are 4 knobs on the back of the unit that get inserted into the legs. BE CAREFUL... the unit is heavy, All you have to do is raise one end of the unit up about 1 1/2" and pull towards you a little. You may have to fudge with it a little until it comes out of the leg, but that should be all you need to do.

If you do have the legs, i'm in need of them... please contact me at [email protected] and please offer me a fair price before i fabricate some out of an old tire or something haha.

GENTILITY lay that set face down on a table covered with a thick blanket. There should be 4 long threaded bolts near the bottom that fasten the legs of the stand inside the framework of the set.. Remove these and the stand should slide right out.

www.mcveyelectronics.com

x37sv-naga.lcd remote control

Try the Hyundai web site, or call their service rep.

Jerry G.