Question about Jenn-Air JDB7910 Dishwasher

1 Answer

No power water in bottom of dishwasher

Water in bottom no power in my jen air dishwasher what do i need to do to fix the problem?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,085 Answers

Clean out the drain pump. Not fun.

Posted on Jun 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jen air dish washer not shutting water

Open the door to the dishwasher. there should be a circular peice on the left or right side of the tub. it maybe stuck. if its stuck. the water won't shut-off.

May 28, 2012 | Jenn-Air Dishwashers

2 Answers

Fridge is leaking water .... there's a place in the back of the fridge at the bottom (where the water line comes in from the in fridge filter and then goes to the icemaker).... there's two electrical...

yes these are the water valve solenoids and 1 is fir ice maker and the other is for cold water supply in the door,yes just replace it dont even try to fix it

Jan 01, 2011 | Jenn-Air JBL2086HES Bottom Freezer...

1 Answer

Dishwasher holds water at bottom after wash is done and cycle ends

Some water at the bottom of your dishwasher is ok. However if the water more than covers the bottom then you have a problem.
  1. First thing to try and this may fix the whole issue. Check the air-gap to see if their is a clog in the line.
  2. If your hose is clear change out your drain line and drain pump parts #99002750 and #99002652
That will fix it for sure. Have a great day!

Dec 07, 2010 | Maytag MDB9600A Jetclean II Built-in...

1 Answer

Out of the blue our Jen-aire jdb1105aws doesn't want to power up. No lights, no cycles etc. Checked the plug etc and no tripped fuses. Any thoughts appreciated.

If there is power present on the controller but not outputting to the circuits then it is possible toi have the controller faulty which can be getting error messages/fault messages from the sensor or a failure of the main board..

Sep 11, 2010 | Jenn-Air JDB1105AWS Stainless Steel...

1 Answer

We have hard water, is there a way to add something to our Jen air dishwasher to avoid the spotting?

Any Rinse-Aid product should work. We have domestic water at my house and it is a bit on the hard side. Will notice a difference when the Rinse-Aid is empty. You may check to see if it working on your unit. If it is extremely hard you may consider a water softening system.

Jul 14, 2010 | Jenn-Air Dishwashers

1 Answer

LG Dishwasher

I can't say for sure, but it is possible this unit is deeper than previous units. The only way to tell for sure is to measure the previous unit and compare to this one.

I would be suspect there may be something simple preventing the dishwasher from going all the way back into the cavity of the cabinets. Maybe the water line is in the way, the power plug, etc. are in the way. You would have to pull the dishwasher out and look it all over to determine if his comments are true or not.

Jan 23, 2009 | LG LDF6810ST Stainless Steel Built-in...

1 Answer

Dishwasher will not turn on. It is a jen air .

I little more information is needed to get specific, like model number and what is actually happening. But the basics need to be covered like:  Check the circuit breaker on the panel to see if the circuit breaker is on and working Move the on/off switch to see if there are mechanical problems with the switch itself  Read the manual for specific things that you can do to get your dishwasher to start Make sure that the door is closing properly and the door lock is working properly Check the bottom of the dishwasher to make sure that nothing has fallen out of the lower rack into the tub and gotten onto the heating element or jamming the float
Hope this helps.

Oct 11, 2008 | Dishwashers

1 Answer

Soap does not desolve

check that the spray arms are turning and that the holes in them are not clogged, if you line them up pointing towards the front let the machine fill then as it starts to wash open the door and you should see the arms slowing down, if they are okay then check the water level which should just lap the filter at the bottom

Jan 07, 2008 | Jenn-Air JDB6510 Built-in Dishwasher

2 Answers

Jen aire ice maker not working

change filter and defrost water lines if frozen

Dec 10, 2007 | Jenn-Air Freezer Jenn Air Clear Cube Ice...

Not finding what you are looking for?
Jenn-Air JDB7910 Dishwasher Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jenn-Air Dishwashers Experts


Level 3 Expert

80339 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers


Level 3 Expert

4350 Answers

Are you a Jenn-Air Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides