- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
GAIL,YOU NEED THE REMOTE THAT CAME WITH YOUR TV IT WILL ALLOW YOU TO ADJUST THE COLOR AND CONTRAST BRIGHTNESS YOU MUST GET INTO THE MENU TO DO THIS BUT YOU DIFFENTLY NEED THE REMOTE THAT CAME WITH THAT TV!!!
Depends on the TV. Get the instruction manual for the TV.
Sounds like you want to reset the TV control parameters to factory default.
This can often be done by manually accessing the menu using the buttons on the TV.
Press "Menu" on the remote select the "Magic Focus" option in the Video menu or press the "Magic Focus" button on the front panel to adjust the convergence of the three picture tubes that create the proper color for the picture. Pressing the button on the TV initiates the automatic adjustment, and accessing the feature through the Video menu allows you to choose automatic or manual adjustment, though the "Automatic" setting must be selected for the button on the front of the TV to begin the process.
Go into the service menu and turn down the red push and red cut a few notches. Write down every value in the service menu and be careful to make sure you don't change anything else. Also, turn down the brightness a couple of clicks and the red glow will be gone.
Or, try this - Press Mute on the remote control twice, press Mute a third time and keep holding at the same time, press the Menu button on the TV front panel. If you do it correctly, you will see a small S on the screen. Congrats, you are in service mode. Press Menu on the remote to get to the adjustable settings. Be careful not to change anything without writting the original value down first. Also be careful of hitting other buttons on the remote. To reduce red push, Use the channel up down button until it says RCUT. Adjust the value using the volume button on the remote. I recommend setting RCUT to 80H, which is the preset value according to the service manual. To exit Service Mode, simply power off the TV. Good luck.
You don't say anything about the brand, but most have a menu or setup button on the remote (and TV) which give an on-screen display of functions available. You should see one for picture adjustments. Perhaps the projection bulb is getting old and dim. This is another possibility.
hi..first check it out the brightness.It is available in the
menu button,available on the top of the tv.If it still doesnt
work Projection TVs have a high intensity lamp as the light
source. They wear out and gradually get dim.You probably
need to replace it.
check it out..
rate my response..
i tell people all the time
if you get into the service menu and hit the wrong buttons
i wont know what you did to it
again if you post here to ask how to get into the service mode you dont have the desire to find the codes on the internet which are readily available as are service manuals
turn on the tv
push mute on the remote till mute goes out
hold down mute button and push menu on front of tv
hit menu again when the s comes up
hit 7 on remote and watch out
you just figured how to reconverge your tv