· Scanner home position sensor failure · Defective scanner motor · Defective main board · Defective dc power supply board · Incorrect scanner drive wire position · FU202 on the dc power supply board open (blown fuse). - Action - Turn the main switch off and on. Check the position of the 1st scanner sensor actuator. Actuated De-actuated Does the scanner motor rotate when the main switch is turned on? No Yes Correct the scanner drive wire position. Check the voltage at CN106-2 on the main board. 24 volts 0 volts Check FU202 on the dc power supply board. Good No Good Replace FU202 Replace the dc power supply board. Check the voltage at CN105-1 and 6 on the main board. 24 volts 0 volts Replace the main board.
Was this helpful?
Yes
No
Popular Solutions for Ricoh Aficio 2022 All-In-One
We have ours on the network, and it is set up to forward all incoming faxes to an email address...
(More)
We have ours on the network, and it is set up to forward all incoming faxes to an email address instead of printing. It was working fine, then it started printing faxes, and on the Communication Failure Report, it is saying the error is #1 Hang up or line fail. The email account is good and is reciving emails just fine. How can we fix this.
I Cannot install Ricoh 2022 with snow leopard. I tried to use the drivers I found in...
(More)
I Cannot install Ricoh 2022 with snow leopard. I tried to use the drivers I found in www.ricoh-support.com but they are for leopard (10.5) and they don't work. I also used the drivers I found from apple (ricoh 2022 gutenprint v.5.2.3) but nothing again. The printer seems to be installed but when I try to print something it doesn't go to the printer (usually it stops at 59% in the quew). The IP adress is right and checked and the printer is on. Do you have any idea? Thanks
Everything I print from my Brother HL-5240 printer comes out with both sides of the paper/check...
(More)
Everything I print from my Brother HL-5240 printer comes out with both sides of the paper/check curled up.