Baumatic BHG630SS gas single burner locked, how can I unlock it?

Baumatic GECE6005 manual page 18


To disable the safety lock feature, you should press the safety lock button for a couple of seconds. The "L0" symbol will disappear from the timer display and you are then able to use the hob in normal operation.

Maybe these steps will help. It would be better if we knew the brand and model but here's my fix for my kenmore

I had to look this up as well:
To unlock the cooktop:
1. Turn all burners to the OFF position.
2, Press and hold the TOP keypad for 5 seconds.
You will hear a single tone and lock off will disappear from the display.

Yes, thats okay when you turn the knob voltage gets sent to the spark module, Then the module sparks all the burner igniter. And frame ignition only happens on the single burner of the knob you turned that sends gas to the burner associated with that knob.


Please rate me a "4" if this information was useful.

You can adjust with small vessels keeper stand .

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking
http://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking
http://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

I have 2 videos for you:

Burner replacement

Burner switches




If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

the 'L' means locked - to unlock turn on hob, hold down front right hand side plate control and minus botton to unlock - see manuals for further details

we have the same problem... try removing the knob, ours works fine without the knobs ????

you have a short in the ignition switches. these are located at the base of every stem under the knobs. In order to get to them you have to remove the entire cooktop, which entails removing all of the burners. The switches are run in parallel on a single harness.