Problem GE WAETER FILTERS - General Electric GE SmartWater Household Water Filtration System - GNWH38F

Hi jbboggeri,

Welcome to fixya!

I would go ahead and open the new set and install them. If you get pressure, you know the others were bad and can send them back for a refund.
If there is no change, you can always put them away and use them again later.

Please reply back and let me know how it went. Thanks,

Handie Andie

Here is the web page for GE. You will probably have to replace the whole faucet. When you call have the model # available for your system so they can supply the appropriate faucet. You may as well order more filters as they will be less expensive ordering on-line. These filters should really be changed every 6 months.
http://products.geappliances.com/ApplProducts/html/GEAResults.htm#Category=Dual_and_Single_Stage_Water_Filtration
These faucets are relatively easy to replace for the do it yourselfer.
RJ

Many times fines from these filters become dislodged and plug up the filter housing. If you have the bypass plug for the filter, install it and run a couple gallons of water through fridge to flush the system completely. The install the filter again. Make sure none of the water lines feeding fridge are pinched or kinked and valve is on all the way.
RJ

Hi,
I would shop around for a different water filter supplier...there is no reason ofr that happening unless you are not changing the filters regularly...like once a month...
most filters are a standard size and it should be easy to get them somewhere else...

heatman101

Pull all the filters out and re-install them. Let the faucet run for a while to purge any air from system.
RJ

This page might help with changing it, as different models vary.

Did you unwrap them? Remove clear plastic?

put more filters in the line from diferend kind water filterd tru 3 or 4 filters are more clean you have to now whath are the thinks making the water dirty like yron or ????

Does this mean that you are now having the right pressure? Since the filters are changed, water should
now flow. Is it all systems go?, that is assuming that
your pipelines are not clogged.

The tank was full of water . The blatter in the tank was empty so I pumped six pounds of air into it and it works great.