How to connect nerf controller without sensor

Is there a Nerf round stuck in the mechanism

That sounds like an internal mechanism issue, parts of the plastic on the inside could have worn down, causing the spring to slip and fire the bullet off.

unscrew the entier gun... all nerf guns are screwed together. you can practically cut the gun in half by unscrewing it. just make sure to put everything back how you found it. good luck to you.

Most wireless controllers have a switch on both the sensor and controller which allows you to select a channel, useful for when you have more than one wireless controller. If yours has such a switch, make sure that both the controller switch and sensor switch are on the same number channel.

Here's one--

Although I am not completely familiar with the internals of the NERF NIGHTFINDER I have a good idea what is wrong.

Sometimes factories screw up, etc...

Lemme get to the point.

The circuit operating your light (if you don't know what that is look it up and find out) is probably not connected. Open up the laser and look online at what the internals look like. Make sure that the circuit is complete.

That's all, email me at [email protected] for more info on modding and nerf guns.

no may ne u need config it manually

Well what do you expect from nerf to make a game controler :S. Buy a regualr logitech or Sony ps2 controler.

Hope this info helps!

Here's the link to the Pelican website with a pdf manual to download.
http://support.pdp.com/ics/support/default.asp?deptID=5553&task=download

the L3 button is Left thumstick pressed inward

R3 is right thumstick pressed inward ;P

pls rate .

Hi Rayjdawg,

Check the battery pack on the back of the controller. It's been known to not have good contact at times. I would also try changing the battery. Good luck. :)