Question about Dacor MCS130 Millennia Electric Single Oven
Attempting to locate temp. sensor to reset.
This is from manufacture service manual:
-F2- Alarm Heating Mode High Temperature
Is activated when the ERC senses a runaway heat condition or when the temperature exceeds
“runaway limits”. The ERC will beep until the cancel or another function is selected. If the alarm
repeats the F2 alarm check the oven sensor and wiring after fi rst checking for a stuck relay. If alarm
goes away verify the oven will complete a clean cycle without any type of failure.
Another words the problem with oven sensor or relay board.
Posted on Dec 18, 2008
SOURCE: the oven light flashes on
This problem is a common failure symptom. This is a bad touchpad, please replace it with new one. You can obtain the part at apdepot.com.
Hope it helps.
Thank you for using FixYa.
Posted on Jul 12, 2011
Tips for a great answer:
Jul 28, 2012 | Dacor Ovens
F3 Error indicates a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Aug 02, 2011 | Dacor ECS136-SBR Electric Single Oven
Jan 13, 2010 | Dacor ECS130 Epicure Electric Single Oven
Aug 27, 2009 | Dacor ECS130 Epicure Electric Single Oven
Dec 18, 2008 | Dacor MCS130 Millennia Electric Single...
Oct 26, 2008 | Dacor MCS130 Millennia Electric Single...
May 22, 2008 | Dacor PCS130 Preference Electric Single...
Apr 25, 2008 | Dacor ECS127 Epicure Electric Single Oven
Feb 18, 2016 | Dacor MCS130 Millennia Electric Single...
64 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: