Question about Jenn-Air 34 in. Expressions CVGX2423 Gas Cooktop

1 Answer

Stove top [gas] JENNAIR

My gas stove top igniters keep ingniting when turned off

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 248 Answers
Re: stove top [gas] JENNAIR

Try carefully cleaning around the ignitors. Also clean hole in burners. Clean the holes closest to ignitors. This can be caused by a crack in ignitor, this requires replacement.

Posted on Nov 05, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Gas stove tops: After 3-4 minutes of the gas being on for one or more burners, all of the ignitors keep on attempting to spark. They keep going even after the gas has been turned off and stop after 5 or...

Hi abbilou_78,

I believe your ignition switches have come in to contact with either water or moisture.

Please read my below Tip on how to fix the problem:


If it does not solve your problem, I'd suggest replacing the ignition switches.

Kind Regards


* If you found this solution helpful, please rate it

Jul 30, 2011 | Whirlpool Cooktops

1 Answer

I have a Jennair model ccg2423 stove top.Only one burner ignites yet the clicking sounds seems heard on all 3 others

Hello, Thank You for using FixYa. I will be helping you today.All four ignitors will spark even if only one is turned on.
Thank You and please rate my answer if it was helpful..

Jun 17, 2011 | Jenn-Air 30 in. CCG2423 Gas Cooktop

1 Answer

My cooktop igniter keeps on igniting for no reason

This problem is due to a short to wires contact on the igniter sometimes this happens after a cleaning of the cook top with water so in this case you just use hair dryer and dry out the ingniter.

Other possible reasons are over heating of the ingniter contact so you have to remove it and clean wire contacts.

Finally the igniter contacts are melt together or sometimes full of burned oil and they need to be replaced. Inginter is not expensive part.

Oct 02, 2010 | Baumatic 34 in. B17.5 Gas Cooktop

1 Answer

How do you replace the ignition module on stove.

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking


Apr 14, 2010 | Viking Professional VGRT362-4G 36 in. Gas...

1 Answer

My stove top now keeps clicking, even when it is

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking


Mar 26, 2010 | Jenn-Air JGD8130 Gas Cooktop

1 Answer

Igniter will not turn off. Makes a clicking sound

Hi, normally what causes the igniter to keep clicking is spilling water or something down into the knob area. The water is causing a short circuit in the switch which is mounted on each burner valve shaft. If unplugging the range for several days to allow drying doesn't fix the problem, then one of the switches will need to be replaced.

Jan 27, 2010 | Magic Chef Cooktops

1 Answer

3 of 4 knobs do not compress to turn on gas

You must replace those controls. Cleaning or loosening them up would be temporary at best and the next time they stick it could be in the open position. Safety first...Eric

Jun 14, 2009 | Jenn-Air 30 in. CCG2423 Gas Cooktop

1 Answer

Spark igniter discharging when turned off

It sounds like somebody clean up the stove and the electric sending unid is wet, try this: the knob that correspond to the ingniter that it's clicking nonestop, take the knob out and you will see the sending unit, pull it out unplug it and dry it out and then try it again, it should work properly after it's dry.
Eddie Rentas
Tupper Lake NY

Jan 11, 2009 | GE 30 in. JGP328 Gas Cooktop

1 Answer

Stove-top burners

Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range RepairBurners Keep on Clicking


Jul 10, 2008 | Belling 27 in. CTC465 Electric Cooktop

1 Answer

Some Burners Will Not Ignite

probably a worn wire to the electrode or a cracked ignitor. you are faced with taking off the hobtop and looking - no easy solution. you should not do this unless you are confident and don't interupt the gas path

Apr 06, 2007 | Dacor Preference SGM466 Gas Cooktop

Not finding what you are looking for?
Jenn-Air 34 in. Expressions CVGX2423 Gas Cooktop Logo

375 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jenn-Air Cooktops Experts

Barrett Palumbo
Barrett Palumbo

Level 2 Expert

1772 Answers


Level 3 Expert

57192 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Jenn-Air Cooktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides