Question about Microtek scanmaker 3840
The scanner has a lock and unlock slides at right corner front, I have the same problem before and it takes long time to figure this out, you will also find how dumb you are with that scanner...
Posted on Jan 04, 2008
Hi Inday, Based on your post/description, there appears to be a mechanical problem with your scanner. It would seem that something is blocking the moving part of the scanner internally. Should you wish to give it a try, you have to open the scanner. Chances are you have to invert with the bottom up to access the screws. There might be 6-8 screws with plastic locking at the sides. Upon removal of the bottom plate, the interior of the scanner would be exposed. There should be practically nothing inside except for a movable bar that is held in place on one side by a guide rail and a plastic toothed belt on the other end. Near the topend would be an electronic board. Check that there is no blockage on the guide rail nor on the path of the roller or the toothed belt. Since this sound more of a mechanical problem (due to the "loud sound" that you heard), it should be visually detectable. Good luck and pls post back how things are or should you need further information. Kind regards from Batangas.
Posted on Aug 20, 2007
Tips for a great answer:
Jan 25, 2011 | Microtek scanmaker 3840
Feb 26, 2010 | Microtek scanmaker 3840
Nov 07, 2008 | Microtek scanmaker 3840
Feb 24, 2008 | Microtek scanmaker 3840
Aug 20, 2007 | Microtek scanmaker 3840
Aug 11, 2007 | Microtek scanmaker 3840
82 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: