Grand Cherokee Laredo Model 2000 Transmission Oil Quantity

Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

RTM
read the manual yet?
car WJ
2000
chapter body
read
page 100
its all there to read.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

that sounds right

replace the struts.

the 1st thing that needs to be done is have a mechanical oil pressure test gauge hooked up to confirm the actual reading, the electronic gauge many times is incorrect.

It is located in the bottom of washer reservoir (bottle).

YOU SHOULD HAVE A SHIFTER NEXT TO TRANSMISSION SHIFTER,WILL IT NOT GO IN GEAR FIRST OFF.

The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.

POSSIBLE CAUSES

• Powertrain control module
• 5 volt supply circuit open
• Check transmission fluid level and condition
• GOV press sensor signal circuit shorted to voltage
• GOV press sensor signal circuit shorted to sensor ground
• GOV press sensor signal circuit shorted to ground
• GOV pressure sensor signal circuit open
• Sensor ground circuit open
• GOV press sensor signal circuit shorted to voltage inside transmission
• 5 volt supply circuit open inside transmission
• Intermittent governor pressure solenoid
• Internal transmission problem
• Oil burnt or oil pan has excessive debris
• Other transmission DTC'S
• GOV press sensor signal circuit shorted to sensor ground inside transmission
• Valve body
• GOV press sensor signal circuit shorted to ground inside transmission
• GOV press sensor signal circuit open inside transmission
• GOV press sensor ground circuit open inside transmission
• Governor pressure sensor (high)

is there any leaks possible dissconnected oil sending oil durring oil change this some times happen or double check oil level on dip stick.

this problem exist internally in the transmission, only a computer diag can help resolve your problem