Question about Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator

5 Answers

Door Handle I have a Kenmore side by side and can't find the model number.  The handle has broke and I cannot find a replacement for it.  The part number is 2203543 but I cannot find a part on any website.  Can anyone tell me what possible model # it may be.  It's black/side by side/ ice maker/water dispenser.

Posted by on

  • 4 more comments 
  • cancow Nov 08, 2007

    N/a

  • cancow Nov 08, 2007

    N/A

  • cancow Nov 08, 2007

    N/A

  • cancow Nov 08, 2007

    remove

  • bugman11 Nov 01, 2008

    I have the same problem except that my handle is white. I can't find one anywhere.

  • harrie holthuysen Jul 04, 2012

    For the door handle 826989 use the #2206934b for black other letters at the end denote colour (thats canadian spelling for color). Hope that helps you. Ps I think appliance pros has it for 35 bucks.

×

5 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Yep, if the engineer had worked for me, I would have fired him/her. I have gone through 3 of them of the past 3-1/2 years until I got tired of it.

That said, it likely brakes at the same corner/corner. You will likely find a cavity inside each broken half. Using superglue and a small flat piece of metal (cut from a metal washer) sized/formed to fit inside cavities when the broken half are pieced together. Trial piecing the pieces together first before glueing them together.

If there are no cavities (solid), try creating one (you may be able to drill/carve out) in each broken half then follow the steps above.

Guaranty better than new and last a whale of a lot longr.

Good luck.

Posted on Jul 04, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

For this information i suggest you to visit www.antiguadoors.com or Contat on +1-925-283-8933

Posted on Apr 25, 2016

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

826898 handle is replaced by 2206934b

Posted on Jul 04, 2012

The part number is 826989, you can find it here...

http://www.appliancepartspros.com/part_details.aspx?image=0&part_id=3092943
or here
http://www.repairclinic.com/SmartSearch/SSPartDetail.aspx?PartID=826989&PPStack=1

I was looking for it myself, good luck.

-Richard

Posted on Apr 27, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Check your Refrigerator in the following location(s) to find the model number.

  • Beneath or Inside Food Compartment
  • On Cabinet Frame
  • On Plate Lower Front or Rear of Cabinet
  • Beside Compressor Door on Right End
  • Near Rear of Cabinet
  • Inside Liner at Top
  • Posted on Nov 08, 2007

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    Back door won,t open on my 02 avalanche


    door handle broke depends on what door handle it is.if door cant be open on out side out side door handle broke.if cant open door on inside inside door handle broke.door handle clip that connects to latch rod broken.when you try open door handle not engage to latch rod.door not going open.have to replace door handle with new clip holds latch rod in place.

    Jan 09, 2013 | 2002 Chevrolet Avalanche

    1 Answer

    Hi, the tabs holding the white plastic handle on my Kenmore dryer lint screen broke. It has part number 348846 WHT on it. Can I buy a replacement handle or do I need the handle and screen assembly? Do...


    Need model number of dryer. open door, should be located there.

    Thanks and Please Rate Me!

    TIPS Provided by: www.HoustonRefrigeratorRepair.com

    Brian Gillespie, President & CEO

    GOFAR Services, LLC

    Aug 26, 2011 | Dryers

    1 Answer

    Driver side exterior door handle broke. just one arm broke off the handle, so its still half on but i can't open my door from the out side. can i use the back door handle to replace the front one? also...


    This iis very coomon, the part of the handle that broke is the part that releases the latch, you will need to replace the handle, the inside door panel needs to be removed to replace the handle, some of these are revited on and you will need to drill out revits from the outside and disconnect the linkage from the inside, hope this is helpful.

    Dec 25, 2010 | 1996 Pontiac Bonneville SE CA Value

    1 Answer

    Broken handle on over the range microwave


    The door handle can easily be replaced on most microwave ovens by removing the inner door panel that goes around the perimeter of the glass. The following link explains how to access and replace the door handle:

    http://www.fixya.com/support/r3696942-microwave_oven_door_handle_replacement

    The average cost for a replacement handle usually averages about $20 - $40. Replacements may be purchased at the websites listed in the link I provided. If the model number you have this question listed under is correct, the part number for a replacement handle is 5304440323.

    If you have any questions, please post back with your complete model number (if different than the one listed) and let me know. I hope this helps you.

    Apr 12, 2010 | Frigidaire FMV156DC Microwave Oven

    1 Answer

    The door handle broke off my GE microwave


    Actually the door handle CAN be replaced at a cost much less than pruchasing an entire new microwave oven. And, YOU can repair this yourself and save the cost of a service call. On MOST microwave ovens, you just have to remove the inner door panel that goes around the perimeter of the glass. The following link explains how to replace the door handle:

    http://www.fixya.com/support/r3696942-microwave_oven_door_handle_replacement

    If the model number is correct, the part number is WB15X322. The cost is about $40. Replacements may be purchased at the websites listed in the link I provided.

    If you have any questions, or if your model number is different than the one listed, please post back and let me know. I hope this helps you

    Dec 31, 2009 | GE Spacemaker JVM1640SJ Microwave Oven

    1 Answer

    The door handle on the dryer broke,


    yes you will need to open the door and remove the screws around the inside of the door and then the outer skin will pull off and you can access the door handle screws

    Jan 31, 2009 | Kenmore 82822 Electric Dryer

    1 Answer

    Broken door handle needs replacing


    I assume you need a paert number for the handle. according to the model number you gave I need to know the color of the refrig in order to get you the correct part number or you can go here input your model number then find youre part yourself. just remeber your looking for your color handle to be sure and get correct one. peyton

    Jan 27, 2009 | Kenmore 55612 / 55614 / 5561 / 655619 Side...

    1 Answer

    Broken handle on sliding door behind driver


    First get vin call toyota parts dept/ get the part its really easy to put in look for screws in little pop ups take screws out then go from the bottom of the door and lift out then go side do the same thing then lift from bottom of door and upward then you will take of vapor or plastic sheet then you just replace the handle thats it then out it back together/ Please rate my response thank you very much

    Dec 28, 2008 | 1999 Toyota Sienna

    1 Answer

    Need to Replace Door Handle for KitchenAid Over Range Microwave Hood Combo KHMS147KSS


    Check out this door frame diagram, specifically number 1805. It clips on to the door frame. Remove it using a dull table knife or something similar (be careful not to scratch or break anything). You will then have access to the bottom screw.

    Mar 18, 2008 | GE Advantium SCA1000H Convection /...

    Not finding what you are looking for?
    Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator Logo

    1,475 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kenmore Refrigerators Experts

    John Tripp
    John Tripp

    Level 3 Expert

    4654 Answers

    minguy15

    Level 1 Expert

    15 Answers

    mike cooper

    Level 3 Expert

    884 Answers

    Are you a Kenmore Refrigerator Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...