Question about Light Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

Bad key switch on 1975 merc. 1150 outboard

Where can i get a new switch/choke switch for this old motor. Have searched internet, but can't locate one. all wires one back old one has insulation cracked or gone. This maybe why engine will not turn over

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,687 Answers

Here's something to try. There are cans of plastic coat to dip stuff into to insulate them. Then you could also try to remove the terminals and use shrink tubes on the wires and then replace the terminals. If only for a short while you can see if that fixes the problem.

Posted on Jun 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1978 merc 85 hp outboard with a bad pump i purchased a used one that works mine has 4 hoses


Mercury Outboard Fuel Pump - Mercury Outboard Forums

forums.iboats.com/Mercury-Outboards/Fuel-Pump
5, 2004 Mercury 225 four-stroke EFI no power to Low Pressure fuel pump. Why please help · Mercury & Mariner Outboards. 13, Mercury 850 (85hp) - Gas pumps through the top carb - Failed fuel pump? ... 1, 1969 7.5 H.P. Mercury (Bad fuel Pump)? ... 1971 · 1972 · 1973 · 1974 · 1975 · 1976 · 1977 · 1978 · 1979 · 1980 · 1981 ...

Fuel Pump Diaphragm replacement Mercury outboard 110 ...

? 4:18
https://www.youtube.com/watch?v=vufekxTVZd8
Jun 22, 2012 - Uploaded by Brad Clark
My last test run of this motor lead me to believe I had fuel pumpissues...so in ... Mercury 9.8 h.p. 110 Outboard Motor WaterPump Repair and ...

How to remove the lower unit on a Mercury outboard motor ...




Dec 01, 2015 | Boating

1 Answer

What pins on the ignition switch are energized when when you turn the key on a 2003 mercury 15 hp 4 stroke outboard?


Red is Battery +
Red/purple is ignition
Yellow/red is startermotor
Black/yellow is motor kill
Black is ground

To have ignition, black/yellow wire must be disconnected
On is red/purple on bat+
To start Yellow/red on batt+
To kill: black/yellow on ground

Jul 29, 2017 | Boating

1 Answer

Motor wont turn off with key


Could be broken wire in loom,or bad connection in loom plug or faulty ign switch which is very unlikely

Mar 17, 2014 | Clymer Marine Maintenance and Repair...

1 Answer

Does a 1985 60hp merc have a choke to help start it or how do I go about doing this yes Im a new boat owner of this kind anyways :)


its on the ignition key ! as you turn it on to first position you then push the key in then as it starts let go and with the control lever on a slight high tickover you mite have to dab the choke a couple of times till it ticks over ! dont over choke or you will flood the plugs ! less is best and just let it warm up before setting off !

Jun 11, 2010 | Light Outboard Motor Boat Bass Fishing...

1 Answer

Merc outboard 115HP 1996 fuel primer/Choke


Hello there
here is a good place to start ok Outboard (wiring A Tachometer To An Outboard, Mercury Outboard Float) safe.gif
merc outboard motors mercury outboard ... diagram of mariner outboard motors johnson outboard fuel problems ... johnson outboard motors ebay 1996 115 hp mariner outboard
  • tipsterdatabase.com/mods.php?id=outboard
  • · Cached page

Aug 27, 2009 | Boating

2 Answers

I have a 50 hp 1975 Johnson outboard. When I turn


There is a switch in the control box that locks out the start unless you are in neutral. Open the box and put in a new switch,this is a safty device to keep it from starting in forward and throwing you out of the boat. Jim OMC retired Mech

Jul 07, 2009 | Boating

1 Answer

Need help replacing solonid on mercury outboard


You may have enough room for a wrench. I have an old ignition set of small wrenches and those are slim. There is also a fitting called a crowsfoot which is thick like a wrench but short and fits on a rachet extension. The 1/4" drive set of sockets are usually shorter than 3/8th. If you have a camera, take pictures and go to Sears with it and buy something to work.

Jun 24, 2009 | Light Outboard Motor Boat Bass Fishing...

1 Answer

Have 1975 Merc 115 h.p. motor. won't turn over with key


it may be your neutral safety switch. Try it again but this time turn the key with one hand and wiggle the throttle/shifter lever at the same time. My 25 johnson does this, but usually I can wiggle the shifter and she'll turn over. Hope this helps.

Jun 23, 2009 | Light Outboard Motor Boat Bass Fishing...

Not finding what you are looking for?
Light Outboard Motor Boat Bass Fishing Saltwater  Base Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Light Boating Experts

ray gallant

Level 3 Expert

51545 Answers

fordexpert

Level 3 Expert

5687 Answers

Ian Summerfield
Ian Summerfield

Level 3 Expert

502 Answers

Are you a Light Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...