Hi im jules_09,theres a problem with the copier because ussually after turning it on it warms up for seconds or a minute,but when it freeze at wait the warm up time is too long,see if if you can get the error code,if there is a error code it the lcd check how long is its warm up time.if it take too long.if you can repair it check the voltage at the power supply board going to the main logic board.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Aug 15, 2015 - 3 posts
Inkjet Printing; LaserJet Printing; Printer Software and Drivers; DesignJet .... Windows 10 Stuck on Welcome Screen ... It is a great place to find the help youneed, both from other users, HP experts and other support personnel.
unplug your laptop, remove the battery and wait for three minutes. then install back your battery and power on. right after you power on your laptop press shift key together with f9. release the keys when the laptop begin to boot. follow the instruction on the display.
Please follow the below steps.
1. Un plug the power chord from the back of the printer.
2. Press and hold the power button of the printer.Wait for 30 seconds.
3. While holding the power button, re-plug the power cable.
4. Turn on the printer, if it is not on.
1. Unplug the power cable from printer when the printer is powered on and wait for 20 seconds.
2. Then, press and hold # and 6 while plugging in the power cord.
Continue holding until it displays Semi Full Reset message in the front panel of the All-in-One.
The printer Board B1: you must shut it down by hitting the Options
button and then selecting Function >Shut down > Shut down
sytem>OK. Then power the machine off with the main switch. If the
Customer has not been shutting off the machine properly and you get the
please wait message you might try reloading system software first
before replacing the hard drive. Or = remove and reseat the printer board, if that doesn't work then
you'll have to reformat the HDD unit and reload system software from a
laptop. If the problem remains, the printer board may need to be
The Color Network Printer Board -B1 has a shut down function. It is for
preventing corruption of the HDD. Be sure to turn off the main power
switch after performing shutdown. To properly shut down the Color Network Printer Board -B1: 1. Press the Option key on the control panel if the copier is in copier mode. 2. Make sure that the LCD reads Idle. 3. Select Functions on the LCD. 4. Select Shut Down from the Functions screen. 5. Select Shut Down System from the Shut Down screen. 6. The message 'It is now safe to power off the system' appears on the screen. 7. Power off the main power switch located on the lower right side of the copier.
* Note- After powering off the copier, wait at least five seconds before powering the copier back on.
Never heard of this model but looks very similar to a Xerox.
3 places to look for
1-open tray and check no paper is behind or on the way up and got stuck.
2-open right side and check bottom lookin ginto the tray, you should see the rubber tires and a black lever sensor, is the sensor ok, is there any pieces of paper on it, is it stuck??
3-look at the fuser section (where it gets hot) can you see any paper there? sometimes they crumble up and get stuck. You willhave to take out the fuser unit and remove the paper.