Question about HP LaserJet M1522nf Multifunction Printer (CC372A)
Posted by Anonymous on
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If your printer is connected in the Network and you are able to print fine than there is no communication Error.
In htan case if you are not able to scan then you need to upgrade the firmware of the printer and install it and i m sure your printer wiill scan scanning on the Network.
Mentioned below is the link to download the latest firmware of the printer.
However before you start sending firmware to the printer you need to make sure that printer driver is installed on the PC.
Thanks and Regards
Posted on Jul 01, 2009
You can try setting the printer back to fabric settings following this simple steps:
1) Turn the printer off
2) Now while the printer is off, press and Hold the down arrow and cancel button
3) Keep them depressed and turn the printer back on while holding those keys
4) you will see a message on the display that reads "permanent storage init" at this point you can release the buttons
After this steps you need to wait about 3-4 minutes and then the printer will come back to ready
Password reset DONE !!
If you need more assitance you can contact me at :
Posted on Jul 14, 2010
Hi the easiest way is a nv ram
1. Turn the printer off
2. Hold down the down arrow and the cancel button
3. Reboot the printer while holding the buttons and hold until permanent storage is displayed. Let go of the buttons and wait for the ready message on the display.
This reset will clear all of your saved settings and contacts, if networked print out a configuration report after resetting the printer to view the ip address (IPV4). If the IP address has changed you will need to update the print driver's port tab and update the port.
Posted on Jul 15, 2010
Hello, if you go to the reports menu from the control pnel, then to the fax reports sub menu.
From there you cn setup all of the confirmations required.
Posted on Jan 17, 2011
SOURCE: My hp laserjet M1522nf is
You need to connect the unit via USB and then run the HP firmware update utility so that the current firmware can be installed. This error is usually caused when a firmware update is interrupted. Current firmware for this unit is 20100902.
Posted on Mar 05, 2011
Tips for a great answer:
Oct 11, 2012 | HP Laserjet M1522nf All-in-one Laser...
Oct 24, 2011 | HP LaserJet M1522nf Multifunction Printer...
May 02, 2011 | HP LaserJet M1522nf Multifunction Printer...
Feb 22, 2011 | HP LaserJet M1522nf Multifunction Printer...
Oct 25, 2010 | HP LaserJet M1522nf Multifunction Printer...
May 20, 2010 | HP Hewlett Packard LaserJet 3000dn Printer
May 19, 2010 | HP LaserJet M1522nf Multifunction Printer...
May 01, 2009 | HP LaserJet M1522nf Multifunction Printer...
Jul 10, 2014 | HP LaserJet M1522nf Multifunction Printer...
88 people viewed this question
Usually answered in minutes!