Does the lamona chimney extractor have a fuse? put in new bulbs but still not working!

If your Lamona 60cm chimney extractor is fused and not functioning, here are a few steps you can take to try and fix it:

1. Check the power supply: Ensure that the power supply to the extractor hood is working correctly. Check if the fuse in the electrical circuit or the circuit breaker related to the extractor hood has tripped. If it has, reset the breaker or replace the fuse.
2. Unplug and wait: If the extractor hood is still not working after checking the power supply, unplug it from the power source and wait a few minutes. This can sometimes help reset the internal components of the hood.
3. Examine the control panel: Inspect the control panel of the extractor hood for any visible signs of damage or loose connections. If you notice any loose wires or damaged components, it is advisable to seek professional assistance for repair or replacement.
4. Consult the user manual: Refer to the user manual provided with your Lamona 60cm chimney extractor for troubleshooting tips and specific instructions. The manual may have a troubleshooting section that addresses common issues and guides how to resolve them.
5. Contact customer support: If the above steps do not resolve the issue, it is recommended to contact Lamona's customer support or contact a technician specializing in appliance repair. They can provide further guidance or arrange for a repair service if necessary.

there are set screws that hold it on

well need to sort the buttons on the side off the doors mate be jammed just flick everyone of each door .

may be an internal fuse / wire burnt off oven control as nothing works

This sound like the pcb for all your cooker hood spares visit our site

You-Tube video "8eLuShj-RAg" placeholder (do not delete)

The fuse will be located in the switch or socket that the hood is connected to. This is sometimes inside the flue on the back wall. There should be two small screws either side of the chimney located at the top, unscrew and slide one part of the chimney down, please be careful as stainless steel has very sharp edges.

Minimum above a gas burner should be 750mm and for electric hob should be 650mm.

Hi - I have a neff extractor fan and have the same problem. The light and fan have both stopped working. Does anybody know where I can find the fuse as I suspect that this may be the problem too?

hood should be connected to a fused spur outlet which you havent found. try removing the chimney and you may find it there. chimney only held by 2 screws at top usually.the fuse in the outlet sometimes goes when bulbs blow