Purchasing a 2005 JD 330 CLC, What are the weakness and trouble spots Has approx 7500 hr

Check the tires to see if the rims/lugnuts are loose, then inspect the tire tread for 'wavey' spots in the tread and/or sidewalls. (Indicates broken belts inside the tire)...If the vibration smoothes-out after 5-55 MPH, it would be tires out of balance...if it gets worse, and is a frontwheel-drive, likely a constant-velocity-joint going bad in one of the front axles. Generally the one one the passenger-side fails first.

I suggest you check your timing chain, or belt for warn. timing belt jump usually diagnoses that behaviour

Look at the shift linkages. If they are loose and out of alignment it will sometimes cause that condition. The linkages where the go into the transmission is a common spot where the splines will get slop in them.

hi all jd info i get from their forum..well worth a look.
The Unofficial John Deere Forum

Hi Craig, sorry to hear your having problems. the first thing to try is running the machine with the fuel cap loose. The cap has a vent that allows air into the tank as the fuel is consumed.

Ensure that the cooling shrouds are clear of and grass / debri buildup causing it to over heat.

If those fail, it is likely that you will need a new ignition module. As the module heats up it expands. if there are any weak spots it will cause a broken internal connection when expanded. When it cools off, it contracts and the weak connection is restored.

Kevin

BRAKE ROTORS WITH HIGH AND LOW SPOTS WILL CAUSE STEERING WHEEL SHAKES ALSO.LOOSE WORN WHEEL BEARINGS - WORN TIE ROD ENDS - WORN LOWER BALL JOINTS.

you have a short in the electrical and i suggest you call a service repairman to have it looked at but he will probably tell you to get a new stove,,,there is no simple solution to this

I have Canon 7000 Laser with Error message #330 which said
SET DOCUMENT??? HELP?

Is it from the copy board glass or the printer part? Doses it show up in all 4 color making a neg copy in each color. If it shows up in the same spot on each color it could be the opc or transfer sheet. Also does it repeat it's self down the page.... Marks can come from one of three places.... opc,transfer,fixing... Need more info...... To broad of a Question