Question about Syma S031 Gyro Metal Frame 3.5 CH RC Helicopter Jumbo Size

1 Answer

Syma s031 battery is charged but helicopter doesn't light up respond to remote

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Expert
  • 117 Answers

Make sure the battery is connected and the Helicopter and remote are both turned on on the same channel. Antenna is secure and extended.

Posted on Jun 19, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My syma s107 isnt responding to my controler

change the batteries in remote controller,,sure for charging indication in flying kit s107,,otherwise describe the fault completely to me

Jan 19, 2015 | SYMA Toys industrial New Syma S107 Radio...

2 Answers

How to fix a syma helicopter if it is not responding

My helicopter used to do that too I called the company and told them my problem they said to change the batteries in the helicopter in a week they delivered the batteries and my helicopter was working agaim

Apr 21, 2014 | SYMA Toys industrial New Syma S107 Radio...

1 Answer

The light on the charger for my helicopter syma S031 with gyroscope remains green even though it needs charging

Mine has also done this. The charger units for these helicopters are mass produced and therefore have a failure rate. I pugged mine in to the mains supply today and it sounded different, as in it 'popped'. The LED failed to light. When I plugged it into my models battery, it went green, even though the battery was low in voltage.

I metered my charger output and it is dead. My S031 is only two weeks old but to get to the shop is a nightmare so I may just open it up and repair it myself (I'm fine with electronics). However, I am not sure if my new battery pack is okay or not, so I run the risk of visually voiding my charger warranty. I have had issues with all of my Syma models and may just get a refund and move on to swashplate 6ch+ machines.

If your charger/S031 is new, I would suggest you return it to the store you purchased it from. Electronics this day and age are a joke and the quality control used is appalling, especially in cheap Japanese models alas.

The charger is sealed and will need to be broken open to access the electronics. Dangerous voltages are inside so I'd suggest you just return it for an exchange.

Jan 16, 2011 | xheli Syma S031 Outdoor RC Helicopter

2 Answers

My heli syma so31 with gyroscope won't play but there is lights both unit and the remote control.

using the left stick push it forward then down to bottom the light on control should stop flashing this means it is synced with chopper

Dec 31, 2010 | xheli Syma S031 Outdoor RC Helicopter

1 Answer

The helicopter syma s032 not fly, noy function, not syncronize with the remote control. This charging for 90 minutes and the battery of the remote control is new. The helicopter light led is good, to...

0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
This should get you flying. Let me know.

hope this helps,

Dec 28, 2010 | SYMA Toys industrial Syma S032 Ready to...

2 Answers

I have a brand new Syma model S031G model toy helicopter. I have no instruction manual. It has been charged and the lights work. My remote has new batteries. But it will not make the blades rotate. Can you...

Looks like a board circuit problem. If its new, you have to return it and replace it with another one, try it before going home.
Try this, open the board, there are two trimming resistor adjustment, one for the rear motor and the other one controls the main motor, try to adjust it while your switching the remote controller to lift.
If that does not work. The little servo on the board are busted and you need to return the product!

Thanks for using Fixya!

Dec 15, 2010 | xheli Syma S031 Outdoor RC Helicopter

Not finding what you are looking for?
Syma S031 Gyro Metal Frame 3.5 CH RC Helicopter Jumbo Size Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Syma Video Game Consoles & Games Experts

Gil Shultz

Level 3 Expert

3368 Answers

Bill Boyd

Level 3 Expert

46527 Answers

John mullen

Level 3 Expert

294 Answers

Are you a Syma Video Game Console and Game Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides