Question about LG WM0642H Front Load

Open Question

My LG will not start - lights come on, door locks then it has a faint humming sound

Earlier in the week, I noticed that it was humming during the spin cycle. Now nothing.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: LG WM1814CW Front load washer PF continues to come on and stops cycle

Seen This before Main control board fixed it It would go through most of the wash cycle and just quit no errors but PF

Posted on Jan 29, 2008

SOURCE: vibration during spin cycle

Unless your front loader is set firmly on concrete and leveled to perfection, the force of a heavy wash load spinning in excess of 1000rpm will create a bit of vibration and noise.A firm footing is your best defense against to much movement.
Also due to the earlier movements during the spin cycle, the shocks that are used to dampen the spin cycle might have been broken or damaged.
If the problem persists inspite of proper levelling, please do check for the shocks or might have them replaced them for good.

Posted on Dec 13, 2008

  • 2 Answers

SOURCE: "le" on the LG WM0532hw front load washer errror

try unpluging for 45 seconds than hold in the selector knob for 10 sec. & plug back in

Posted on May 18, 2009

pappapumpdaf
  • 635 Answers

SOURCE: LG Tromm wm 1814cw makes loud noise

You will need to remove the back cover plate of the machine and locate the large pulley at the end of the drum. Remove the belt, then the pulley and you should see a bearing housing. Some models require a bearing and housing replacement, while others can simply be repaired with a bearing replacement alone.
Go here, and find the nearest Dealer for your part.

http://www.1stsourceparts.com/contact_us/branch_info.asp

Or you can try ordering direct from LG. If you are as handy with tools as you say, this should be a fairly easy job.

Posted on Mar 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a LG Front Loading Washer, Mdl. WM2601H. My wife was doing a load and I believe load became unbalanced. This was on the wash cycle not the spin cycle. She kept pushing buttons and the display went...


Did you try switching the power on whilst holding the start button only for at least ten seconds.if you can pull the machine out enough to tip it 45 degrees toward the rear so no water leaks when you open the penny trap to see if a button of coin has lodged in the drain pump.good luck.

Jan 13, 2015 | LG Washing Machines

1 Answer

Duet dryer is making a humming noise when cycle starts a d during


whenever i hear a humming sound in a dryer it's usually the motor or something caught in the blower wheel stopping the motor from spinning.open the door and see if you can spin the drum.if it spins by hand try this,open the door,push in the door switch with one hand,have someone push the start button while you hold in the door switch and spin the drum by hand helping it move,if it runs you have a bad motor,if it doesn't remove the bottom panel and see if the belt is broke and stuck in the motor but like i say usually it has something to do with the motor not spinning.hope this helps

Oct 21, 2013 | Whirlpool Duet Sport 6.7 Cu. Ft. Gas Dryer

1 Answer

My 1996 plymouth voyager started to show short when I open either door. Heard clicking earlier when used left tyrn signal. Sounds seems to come from below junction block but I cannot see sparks or wor


There is a wiring harness that feeds to the door, electric door locks and windows draw a lot of amperage. Try removing fuses one at a time that supply power to your door controls until you see the problem go away. If that doesn't work, try other fuses to accessories like interior lights. If your headlights are dimming you have a power wire shorting to another circuit, if it were to ground it would blow a fuse.

Apr 30, 2017 | 1996 Plymouth Voyager

2 Answers

LG Tromm WM2277HW


Does spin only work well?

Apr 11, 2017 | LG WM-2277HW Front Load Washer

1 Answer

Humming, but no spinning


It could be the capacitor which kick starts the motor.

they are relatively cheap to replace.

Ash

Oct 22, 2009 | Frigidaire Dryers

1 Answer

LG LFX25960SW Refrigerator--Display goes bizerk


It is going thru a diagnostic process, But this is only to happen when you either open the circuit board and press the test button, or use the front display keypads. I would have the circuit board checked

Jul 27, 2009 | LG LFX25960ST Stainless Steel French Door...

2 Answers

92 Ford Taurus Won't Start


The hum you hear is the fuel pump. I would start with the battery and have it load tested, then I would pull the starter and have it tested.

Jun 21, 2009 | 1992 Ford Taurus

1 Answer

The washer just stopped pouring water. Only faint humming sound.


Cool!

How 'bout a FixYa for the effort, and let me know if you need anything else.

Feb 04, 2009 | Whirlpool Ultimate Care II LSQ9549L Top...

2 Answers

Beko 520w wasing machine


Hi see the last video on this it will show you test mode or if your beko wma10w washing machine wont drain or has a spin problem then you have to check the carbon brushes first.

Also check all waste pipes are clear and inspect the pump I have included this video below.

At our website I am doing self diagnostic videos on these beko's as we speak so all tutorials will be in this link below
How to replace Beko Washing Machine Motor Carbon Brushes
you might find this test video helpful but only do it if you have checked the motor

Mar 08, 2008 | Washing Machines

1 Answer

Buzzes will not spin


Plug off the wall, check behind for the belt may have come off.

Dec 16, 2007 | Frigidaire GLTR1670A Front Load Washer

Not finding what you are looking for?
LG WM0642H Front Load Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...