Haw i cant fix the error 0*c004c003 - Computers & Internet

Two possibilities come to mind:
1)
Change a setting in the service mode this might help it has cured a few E002s for me go into service mode *28* >copier>option>body>>> adj fix temp to 4 normally set at 0 is adj from 0>7 ..I had changed fusers for this problem b4 but this cured the error for me ..good luck..
Note: to enter service mode press *, then 2 and 8 simultaneously, then 8.

2)
Other possibility is to just clear memory. Again use *28* as above, then press copier, then function, then clear.

That looks like a general error. Does your internet connect?

In my printer paper side is a piece of wire and I cannot take it out. so the printer say erore as is a paper jam problem. Haw can I open this zone to take out the wire?

h2 is a fusing/fixing unit problem.also check connector of fusing/fixing unit.

cud be poor quality disks you are using, depends
macs are quite reliable so I cant blame the drive itself
toast isnt part of mac and there are reliablity issues from it.

If i remember by playing it with my gf you cant adopt a pet you make one when you make ur family.. So Do this before you start you sims pets.
Cheers.

press dot ( . ) on the left side of 0 so we could know whats the second defree number is. to reset press energy saver once then 107 press stop button until 1 blinks then 5 # 810 # turn off copier then on.

haw i fix cookies token yahoo messenger

Sharp Fuser
H2-0 Fusing unit temperature error
H4-0 The fusing unit doesn't heat up.
***ALWAYS DISCONNECT POWER WHEN WORKING ON MACHINE***
You have to reset fuser errors with simulation 14. Push P * C * then 14 then Start (the button you use to make copies) and it should reset the code. If not then replace the fuser.
SM 5-1 should turn the lamp on. If lamp blinks on and off it is the thermistor, if it does not it is the lamp, but check the contacts on the lamp/fuser -- they have been known to erode.
Also check thermal fuse, if defective replace.

Turn on the power holding 0&8, key in 89, and press print. A 3 will probably be displayed. Key in 0 and press start. Recycle power.