Question about Rockwood X-Plore AMP-4030 Car Audio Amplifier

# Whatare the resistor values? - Rockwood X-Plore AMP-4030 Car Audio Amplifier

Posted by Anonymous on

×

my-video-file.mp4

×

## Related Questions:

### Values of the resistors

Resistors R1, R2, R3, and R4 are arranged in a circuit as shown in the figure above. The direction of positive currents I1, I2, I3, and I4 through the resistors are shown. (i.e., negative current values correspond to currents in the opposite direction to that shown above). The values for the resistors and the batteries in the circuit are: R1 = 100 ?, R2 = 200 ?, R3 = 30 ?, R4 = 400 ?, V1 = 4 V, and V2 = 12 V.

Nov 06, 2016 | Televison & Video

### What is the value of resistor 601

600 ohms

A resistor with a number code instead of a letter code is a SMD:
Surface Mount Device. You might have searched for SMD resistor code and got some hits.
The system for SMD resistors is:
1st value-2nd value-multiplier
6 - 0 - 1 following zero
= 600 or 600 ohms
603 would be 60,000 Ohms or 60k
6 - 0 - 3 following zeros

Mar 21, 2016 | Televison & Video

### How do i unlock sharp crt tv model 21v-fk200m? i forgot the ...

www.fixya.com/.../t25439922-unlock_sharp_crt_tv_model_21v_fk200...
Feb 17, 2015 - Question about Sharp Standard (CRT) Televisions .... What is the valueof resistor R704 in SHARP TV model 21V-FK200M circuit diagram.

### Sharp value 2 watt resistor Standard (CRT) Televisions ...

www.fixya.com > ... > value 2 watt resistor > Standard (CRT) Televisions
value of r707 sharp model #27c241 R707 is 27 ohm 1/2 watt carbon resistor,if you ... What is the value of resistor R704 in SHARP TV model 21V-FK200M circuit ..

Dec 28, 2015 | Sharp Televison & Video

### Can anyone tell me the value of the resistor in a Kitchenaid K5A mixer. I think mine grew legs and walked away. Thanks, Mike

Are there any colors on the resistor or it is missing. If you know what the voltage and current should be in the circuit you can calculate the resistor value.

May 08, 2014 | KitchenAid K45SS Classic Stand Mixer

### Radio Shack Multimeter, 22-168a, shunt resistor value????

Go to the Radio Shack site and you may with the model number find a schematic or you can email/contact them for the value of the resistor.

I predict it is a precision value and type you will have to get from them if available.

PS: you posted in wrong catagory as this is TV section.

Mar 12, 2012 | Televison & Video

### I have two crack green resistors colors are red, brown silver gold. what value is this. Its on the power board of a 24 dell monitor

The value = 0.21 ohms 5% tolerance
Use this WEB site to work out the value of the resistor.
http://www.smpspowersupply.com/resistor/resistorcolorcode.html
This WEB site gives you the color code values for resistors.

Mar 01, 2011 | Computers & Internet

### I replaced my convergence chips and I still have a convergence problem. Its not as bad but I still cant line up the blue convergence cross exactly

Sounds like your over half way there lol..
You now need to check the resistors positioned near the convergence ic's. They are your likely problem and go bad often when the ic's fail.

They are normally about 2watt and the values will vary but normally are like .10 ohms to 1 ohm.
I cant find a schematic to give you the exact values and locations but if these resistors measure off value at all you need to replace them with the exact value of the originals.

Heres a link to resistor color code guides just in case the value numbers are not printed on the resistors
http://www.dannyg.com/examples/res2/resistor.htm

Good Luck!!!

Nov 24, 2010 | Panasonic PT-53WX42 53" Rear Projection...

### I have a resistor problem in sanyo ST-21G1

it's very difficult to give the exact value of that resistor.,but i can give some tips to find the value of the said resistor .( find how the resistor works, it is a dropping or fusable? if fusable used .47 or 1 ohm resistor if it is a dropping resistor you should make a trial and error .from 100k,10k or 1k.

Oct 29, 2008 | Televison & Video

### Burn resistor

if its a 4 band resistor, use the following calculator...
http://www.dannyg.com/examples/res2/resistor.htm

if the resistor is a 5 band, use the following link....
http://www.sizes.com/materls/resistorcolor.htm

hope this helps!

Jun 16, 2008 | Dell E773C 17" CRT Monitor

### Sony resistor values?

It is recommended to use the same value due to the function of the resistors and their values.
A lower value will let the current flow a bit faster and the higher value will slow it down according to their design.
Try installing the same value of 220 ohms.
Hope this helps.

May 05, 2008 | Audio Players & Recorders

## Open Questions:

#### Related Topics:

30 people viewed this question

Level 3 Expert

Level 3 Expert