LG Air Conditioner LWHD2500ER - Change air testing of 3 min to 5

The Energy Saver mode is activated by using the hand held remote control, that comes with the unit. Pressing the Energy Saver button activates it. Once activated the fan will shut OFF when the the compressor does. After which, about every 3 minutes the fan will turn ON to check the room air to determine if cooling is needed.

It sounds like, you're missing the hand held remote control?

Yes, Nicole it is. If the room is cooling down like it should. It actually is saving you money. As the compressor uses more energy than fan.

Hope this helps you.

Check the capacitor

To get proper cool, keep the tips as follows:
1. Check air filter is cleaned. 2. Check indoor coil is cleaned. 3. Checkindoor blower motor is working. 4. Keep in cool mode. 5. Set temp minimum 3degrees less than room temp.6.Check compressor is working with correctpressure.
Thanks. Helpful?

The unit isn't kicking out any water. And its not cooling like it normally does. How can I fix this issue?

The compressor has an overload. Your description sounds like it is cycling. It may be a faulty overload, but typically that is a symptomof a compressor or refrigerant charge problem. Typically not worthy repairing on a window unit.

www.appliancefactoryparts.com/content/.../118816.pdf - United States
Above is your service and repair manual, with this you will be able to troubleshoot and repair your Aircon.
I suspect, your thermostat may have a faulty sensor?
factoidz.com/troubleshooting-your-air-conditioning-thermostat/

http://www.inspectapedia.com/heat/Thermostats.htm

Below is a DIY AC, troubleshooting how to. http://www.repairclinic.com/Air-Conditioner-Troubleshooting

If you have a low pressure switch on your air conditioner it's opening and closing, because you don't have enough refrigerant in the system or it's cycling on the thermal overload in the compressor because it's getting hot.
You need to charge your system to approximately 12° to 15° superheat not by pressure.

dont pull the AC as it need some technquie and force . if ice is forming on evaporator coil then certainly the refrigerant is low , or the fliters are choked as the circulation of proper air is not done..

It depends on the (EER) Energy Efficiency Ratio,which is capacity divided by watts.
Example 35000 btus / 2500 watts = 14 EER
If you know the capacity,btus and EER you can calculate the watts, capacity / EER
Example 35000 btus / 14 EER = 2500 watts.

EER is determine by testing the air conditioner at Department of Energy Guidelines, which are
80° drybulb 67° wetbulb indoor and 95° and 82° drybulb outdoor.