Question about Televison & Video
I have a Sylvania tv model number SRT2232X it stays black when turned on and no sound but flahes when its turned off
Main board fault. Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" or "Magazine" will make surf easy. Surf the site with patience. Pull up older posts.
Posted on May 10, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 32" Sylvania SRT2232X
If still under warranty or if you have no electronic repair experience you should take the set back to the shop or to a repair person. Some of the solutions described below can be dangerous, TV's are very hazardous to service. Even when plugged out, TV's can store very high voltages. Generically speaking anything in the horiz deflection, hv development area will cause a no pix symptom, also a problem in the signal processor section, video river and output section as the crt/socket assembly. I would also check the lopt transistor and probably the fuseable resistors around the lopt.
Posted on Mar 23, 2006
With the TV disconnected from the mains, remove the back. Clean out dust with an artists long wooden handled brush, see if anything is burnt or blackish. Do not disconnect anything to do with the Tube. Check for any disconnected wires. If all looks well, you may try it with the back off, but do not fiddle with anything in the back, while switched on. Look at the tube base just in front of the Printed Circuit Board attached to the tube base. You should see a glow from the three filaments which heat the cathodes. If there is the tube is still OK, But the line timebase has stopped working. If nothing is working look for blown fuses. Do not just replace them, but let a service engineer know, or write to FixYa again giving more information and your own capability.
Posted on Oct 19, 2006
SOURCE: Sylvania 27" TV
replace the yoke return cap. Its a polyester cap. probably 0.33uf and blue. trace back from the yoke connector plug pins. Other than that, look for bad solder on the yoke plug.
Posted on Jan 24, 2007
Tips for a great answer:
Jan 20, 2016 | Sylvania Televison & Video
Feb 22, 2013 | Sylvania SRT2232S 32" TV
Feb 12, 2010 | Sylvania LC320SS8 32 in. LCD Television
Jun 06, 2009 | Sylvania 6413TC 13" TV
Nov 08, 2008 | RCA RCU600M Remote Control
Oct 19, 2008 | Air Tools & Compressors
Mar 23, 2006 | Sylvania 6413TC 13" TV
20 people viewed this question
Usually answered in minutes!