Question about Hotpoint Aquarius WD640 Front Load Washer/Dryer
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
remove bottom rear panel. you will see a large diameter hose going from tub to pump. undo this hose at the tub end - lots of water will come out. filter is inside this hose. remove and clean
Posted on Jul 17, 2008
SOURCE: does machine have a filter
The filter is to be found at the rear of the washer.
Remove lower rear panel of washer, remove large black hose fastened to bottom of tub.
Watch out for water running out.
Remove plastic`filter inside hose and clean.
Refit filter and hose.
Dirty washing can somtimes be attributed to washing at too low a temperature, so make sure you have selected right temp for washing.
Please leave a fixya rating for my solution.Thanks.
Posted on Feb 08, 2009
SOURCE: hotpoint aquarius extra filter
Normally in front of machine.Remove down plastic cover and then you see pump/filter,open and clean and make sure pump rotor is free to run.Jan
Posted on Feb 15, 2009
Try doing a couple of really hot washes without any clothes in the machine on the second one add a good dose of washing soda to the drum before you fill the machine up
Cut down on load and use some old fashioned soap powder which has bleach and other stuff in it to destroy the bacteria which is in the fats left behind in the machine because of Cool washing
Posted on Jul 07, 2009
HI. the filter is mounted on the drain pump housing. You will need to disassemble the unit to access the filter. Here are some other areas i would check, also.
1. Clogged drain line or water pump
Check to see if there's something stuck inside the pump or the drain hose connected to the pump (pump is usually located at the bottom and towards the back of the washing machine).
2. Water Pump
If the drain line isn't clogged, you may have a problem with the water pump such as a frozen pulley or a broken impeller. If that's the case replace the water pump. Note: if you have a belt driven washer, check the belt(s) for cracks, as this would be a perfect time to replace the belt(s) if needed.
NOTE-If the hoses filter,and pump check out ok, this will confirm that there is a serious issue within the actual control sector(Timer module or control board). It should be replaced i this case.
Posted on Oct 25, 2009
Tips for a great answer:
Jun 15, 2012 | Hotpoint Washing Machines
Feb 28, 2011 | Hotpoint Aquarius WMA42 Front Load Washer
Jan 31, 2011 | Hotpoint Aquarius WD63 Front Load...
Oct 21, 2010 | Hotpoint Aquarius WD63 Front Load...
Oct 21, 2010 | Hotpoint Aquarius WF000 Front Load Washer
Dec 07, 2009 | Hotpoint Aquarius WMA52 Front Load Washer
Nov 11, 2009 | Hotpoint Aquarius WF210 Front Load Washer
Sep 11, 2009 | Hotpoint Aquarius WMA42 Front Load Washer
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: