Question about Hotpoint WD62 Front Load Washer / Dryer

2 Answers

Hotpoint washing machine leaks at soap drawer

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 212 Answers

Check for any in drawer. if not relevel unit. make front a little higher than rear

Posted on Jun 22, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Your water pressure is too high for the machine. You just need to install an inline valve (about a quid) which will allow yout to control the flow/pressure.

Posted on Aug 20, 2009

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dazmaraz
  • 67 Answers

SOURCE: Hotpoint WD64, leaking water from soap drawer

your condenser is blocked,you might be lucky and get away with just cleaning it, but most of the time it is just best to change it. You will have to take the back off again it is the plastic component with the fan motor attached, disconnect the 2 black tubes to it [note where they come from] unscrew the 3 bolts at the bottom , disconnect the wires going to the fan motor. If you are going to change the condensor you will have to take the fan motor off aswell MAKE SURE YOU DISCONNECT THE MACHINE FROM THE MAINS. GOOD LUCK

Posted on Aug 07, 2007

dazmaraz
  • 67 Answers

SOURCE: Hotpoint Ultima WT965 - Water gushing out from door and soap drawer

you have a blocked filter, unplug from mains, take off back panel you will see a black sump hose coming from the tub to the pump, tilt the machine forward and put a dish or bowl under sump unscrew clamp and pull off slowly to release any water in the drum. You will find a blockage, also what appears to be a ping pong ball dont throw away it is meant to be there.

Posted on Mar 07, 2008

barkencoa
  • 3463 Answers

SOURCE: Soap powder remains in the soap compartment

Depending on which compartment the powder is remaining in, it could be low water pressure causing the problem.
If it is taking some down, but not all the powder, then try putting the powder towards the front of the compartment.
If all else fails then I suggest you get one of these dispenser balls that you put straight in the drum with the washing.
Plz rate this solution.
thanks.

Posted on Dec 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hotpoint soap drawer leaking, wfooo


The problem is not a leaking soap container. The problem is that it is overflowing because the line from it to the washer tub is clogged. This happens mostly when using powdered detergents. Check you operating instructions for soap dispenser cleaning procedures.

Jan 03, 2015 | Hotpoint Washing Machines

1 Answer

Water leaking from soap drawer all over the floor during rinse cycle (I think)


probably find a blockage at back of drawer, check the small pipe in the drawer, and unblock this should solve problem

Dec 29, 2009 | Hotpoint Ultima WF860 Front Load Washer

2 Answers

Hotpoint WMA40 washing machine is leaking from detergent drawer- any suggestions ? Thanks


Hotpoint WMA40 washing machine is leaking This video will show you how to find that leak on any front loading washing machine
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.
And don't forget to like us on facebook

Nov 27, 2009 | Hotpoint WMA40 Front Load Washer

1 Answer

At 20 minutes the drawer leaks


have you removed the drawer and cleaned the soap drawer holder ? as these can be blocked and cause this fault

Sep 15, 2009 | Hotpoint Aquarius WD640 Front Load...

1 Answer

Leaking washing machine


TO FIX THIS PROBLEM I WOULD FIRST TAKE OUT THE SOAP DRAWER AND CHECK THE HOSE AND MAKE SURE IT IS NOT CLOGGED WITH WASHING POWDER AS IT CAN BECOME HARD AND BLOCK THE PIPE BY 50% ALSO CLEAN UNDERNEAT AND AROUND WHERE THE SOAP DRAWER SLIDES IN REGARDS UNDER THE DOOR MAKE SURE THAT THE RUBBER IS SPOTLESS AND SITTING PROPERLY .CLEAN UNDER THE DOOR AS WELL.

Jul 14, 2008 | Hotpoint Aquarius WD63 Front Load...

Not finding what you are looking for?
Hotpoint WD62 Front Load Washer / Dryer Logo

Related Topics:

358 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

puggy666

Level 1 Expert

48 Answers

ptpumpman

Level 3 Expert

407 Answers

Cindy Wells

Level 3 Expert

5127 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...