BREVILLE BBL600 BLADE ASSY SCREW TYPE NO locking tabs

Most blender / mixers have one safety switch per jug.
If your BBL300 has one jug then it should have one small switch where the jug's locking tabs will lock the jug into position.
This is usually visible as a small plastic piece (may be black in color) just under an L-shaped groove on the base.
This is a "Normally-Open" switch, so that only something pressing the switch lever will switch it on.
No jug no work. You need jug.
You can test the spindle & motor by switching on (low speed) then use a flat plastic tool (eg a plastic spoon handle) to press this switch tab in.
If it starts, motor is good, then you can buy a jug to fit.

You need to lock the blades from turning and undo the bottom clutch drive in such a way as you do not damage it. I use an old motor clutch drive to undo them myself. It has a left hand thread and a block of wood to hold the blade. Then you can remove the blade with shaft from the brass bush to clean and lubricate it. If the brass bush has moved up in the plastic housing you need to press/bang it down again. Then reassemble. If you wreck the clutch drive on the blade you will need to buy a new blade assy if it is separate to the beaker, if not you will need a beaker and blade unit complete.

It will either be the rubber gasket (it goes between the glass jar and the blade assy) or it could be a worn bearing/bush around the chopping blade shaft. Replace either the gasket or the blade assy.

Me too!

First thing is to find the small hole on the plastic piece below the drive socket and remove the silicone in from it. Next turn the drive socket until the little arrow on the drive socket lines up with the hole, then look thru the hole to see the allen wrench screw in there loosen screw to remove drive socket.

The jar has to be on for it to blend.

If you replace the jar first check the printing on your old jar. If your jar has blue print you will need a new jar and blade, Breville redesigned the jar and now the old blades don't work with the new jars. You tell the difference between the jars by the print color, old is blue, new is white.

BBL600XL/06A jar part number
BBL600XL/14A blade part number

Contact Breville at 1-866-273-8455 for service center locations.

Breville CBL10 has been a fantastic appliance but now electrical section works at slow speed only so I will get rid of it, however the glass jug complete with lid, blade etc is still perfect. Does anyone need this part? I am in Rockhampton.

Grease can only creep into the blender vase if the oil seal has worn out, or the blenders blade shaft is worn and wobbling. Try cleaning all parts in alcohol to soften the seals. Rebuild kits and replacement blades can be found here (http://www.brevilleusa.com/breville-parts/blending.html)

If you get desperate I have access to seals for the BBL600 (the Australian equivalent) but would need to know if the blade assembly is a screw in or lock in type.

I need the blend jar for Breville Blender electronic Model BL3. I did not notice that a stainless steel spoon was in the blender. When I switched it on the crossed blade broke off.