Re: My ps3 12GB slim line truns on for about 1min an...
Have you tried replugging all the cords in? Also have you cleaned the vents to remove dust bunnies? Any beeps or error codes other then start up/ shut down.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi this is a very common problem, the problem is to do with the inverter board inside the telly this board will need replacing before the telly will work again, its not something you can do yourself as the inverter board requires the whole telly to be taken apart and the screen coming out of the case just to get to the inverter, shop around some of the tv repair shops and see what prices you can get,
if the telly is less than a year old then have a word with the shop you bought it from as you may be covered by warranty as you usually get 12months warranty.
if its older than 3 years then you would be better off replacing the telly as it wont be long before something else starts failing on it.
let me know if you need further assistance ok
plz rate this solution as i have a whole page of unrated posts.
im sorry i couldnt give you an easy fix but without getting this inverter board changed it just wont work, the board itself is not that expensive to buy but its the hourly rate that costs so shop around and see what quotes you can get on the cost of repair, check any warranty first as this fault will be covered
Take off the speaker grill and the particle board just behind it. You'll find a block with six knobs. The 3 bottom knobs can be adjusted ever so slightly to fix your problem. Do it very slowly. You wan to adjust the center knob for green. Turn it until the lines go away. But again, do it very slowly. You're adjusting the voltage to the green tube. Do it too fast and you can damage it.
Your set has a cold solder connection somewhere inside that is effecting the scans. You will have to bring the set in for service. I would not use it this way, because it is possible to have some damage that would be expensive to service.
×