Question about Contour Design 00903-0 SurfaceSound Compact Bluetooth Speaker Speaker System

3 Answers

I threw away my instructions on my Contour Design BlueTek

I threw away my instructions on my Contour Design BlueTrek bluetooth and just picked up the 3GS. I forgot how to pair them up. Please help.

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Here are the instructions from the manual for my Contour Design SURFACE SOUND COMPACT (with minor editorials)

To initiate pairing:

  1. Place the bluetooth device and your mobile phone within 0.3 meter (1 foot) of each other - I prefer to place both on a table infront of me
  2. Switch on your phone and select it Bluetooth discover mode (you'll have to figure this one out on your own!)
  3. Immediately after turning the bluetooth device on (ie. lifting the microphone), press and hold both the TALK button and the VOL + button for about 5 seconds until the indicator light flashes red and blue alternately and a sound can be heard in the speaker - I had trouble getting it to co-operate once it started into the seeking handset mode of beeping, so try to press the two buttons before all that beeping starts
  4. Once the mobile phone detects the carkit, a "contour SSC" message will be displayed. Follow the phone instructions to accept the pairing. The PIN coade (or passkey) is 0000, then press "yes" or "ok". I assume the PIN code is the same for all of them, as the manual appears mass printed.
If the pairing was successful, the indicator light will switch to blue and flash slowly. If you haven't started the discovery mode within 5 minutes, it will stop. In this case, you must start the pairing again as step 3 above.

Posted on Jan 05, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Http://retail.contourdesign.com/?/products/13

Posted on Jun 23, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Does anyone have the instructions for a Blue Tek Wii charger? Note! Not a Blue Trek device a Blue Tek device. Are they charging with a rapid red flashing light or what does this mean?

Posted on Aug 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have lost the manual to bluetrek and have an iphone 3 now and need to get the bluetooth working with this new phone


First, here is the link to the manual:
http://www.bluetrek.com/getfile.php?source=/download/product_download-manual63.pdf&filename=CompactClassic+Manual%2C+English&file_extension=pdf
Here are the instruction: 1. Switch on your Bluetrek and press and hold Talk button and Vol+ button for about five seconds untill indicator light flashes red and blue alternatively and you will hear a sound from speaker.
2. Open bluetooth in Iphone 3 search for bluetooth device. You will see Bluetrek Compact Classic. Click on name to pair and enter "0000" as pin code.
Bluetrek will be connected to iPhone.

Jun 02, 2011 | BlueTrek Compact Classic Ultra Slim...

1 Answer

I don't have the manual anymore and I forget how to pair the blue trek car kit with my phone. Please help!


Try this:

1. Put them close together
2. Switch on phone and select bluetooth discover mode (make sure it's visible to other devices)
3. Switch your BlueTrek device. Press and hold both Talk and Vol+ button for about 5 seconds until the indicator light flashes red and blue alternatively and sound can be heard from the speaker.
4. The phone should then detect the Bluetrek device. Follow the instructions from the phone to accept the pairing request. If you didn't change it, the PIN code should be 0000 (zeroes).

Hope this helps.

May 04, 2011 | BlueTrek Surface sound Duo Bluetooth Car...

1 Answer

How do i pair my bluetrek kr1 car kit (lost instructions


Just paired mine, think I pressed all 3 buttons at same time and 1234 was passkey

Feb 22, 2011 | BlueTrek KR1 Wireless Bluetooth Car Kit...

1 Answer

Need code for g2 earpeice


Pairing the BLUETREK® G2
Before using the BLUETREK® G2 headset, you must pair it with your Bluetooth® mobile
phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can
communicate.
To initiate pairing:
1. Place the BLUETREK® G2 and your mobile phone within 0.3 meter (1 foot) from
each other.
2. Switch on your phone and select its Bluetooth® discover mode (refer to the
Bluetooth® mobile phone user manual).
3. When the BLUETREK® G2 is switched off, press and hold the TALK button for
about 7 seconds until the indicator light flashes red and blue alternatively. And a
sound can be heard in the speaker.
4. Once the mobile phone detects the headset, a “BlueTrek G2” message will be
displayed. Follow the phone instructions to accept the pairing. The PIN code (or
passkey) is 0000, then press “yes” or “ok”.
If pairing success, the indicator light will switch to blue and flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset

RATE THIS SOLUTION
RNJ VINOD KUMAR

Sep 19, 2009 | BlueTrek G2 Consumer Headset

1 Answer

Instructions please


Hi - You can download the manual from the link underlined in blue below:

BlueTrek > G2

cdba666.jpg

Please take a moment to rate this solution & let us know if the information given was useful to you - Good Luck!

Aug 06, 2008 | BlueTrek G2 Consumer Headset

12 Answers

Need PIN for Just wireless bluetooth


I threw away my instructions for my bluetooth just wireless model #bt-5 and I cannot find the pin number i need to add to sinc up my phone, can you help?

Sep 23, 2007 | Just Wireless HandsFree Earboom Silver...

1 Answer

Nokia 6680 wont connect to Bluetrek G2


Just had the same problem.

But I found some bluetrek instructions on the net & it works

 

Pairing the BLUETREK® G2

Before using the BLUETREK® G2 headset, you must pair it with your Bluetooth® mobile

phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can

communicate.

To initiate pairing:

1. Place the BLUETREK® G2 and your mobile phone within 0.3 meter (1 foot) from

each other.

2. Switch on your phone and select its Bluetooth® discover mode (refer to the

Bluetooth® mobile phone user manual).

3. When the BLUETREK® G2 is switched off, press and hold the TALK button for

about 7 seconds until the indicator light flashes red and blue alternatively. And a

sound can be heard in the speaker.

4. Once the mobile phone detects the headset, a “BlueTrek G2” message will be

displayed. Follow the phone instructions to accept the pairing. The PIN code (or

passkey) is 0000, then press “yes” or “ok”.

If pairing success, the indicator light will switch to blue and flashes slowly.

If you haven’t started the discovery mode within 5 minutes, the headset

Jun 26, 2007 | BlueTrek G2 Consumer Headset

Not finding what you are looking for?
Contour Design 00903-0 SurfaceSound Compact Bluetooth Speaker  Speaker System Logo

2,632 people viewed this question

Ask a Question

Usually answered in minutes!

Top Contour Design Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

5113 Answers

The Knight
The Knight

Level 3 Expert

74198 Answers

Are you a Contour Design Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...