Error 1687 canon mx451 - Canon PIXMA iP1800 InkJet Printer

On what? Make Model please.

Your vehicle is in limp mode.

Hi Rex, if you get this on your display please give us a call so that we can walk you thru this diagnostic, you can reach our Product Support Team at 800-229-1687 as they are here 24/7 ready to assist, Thanks, JT

# scan tidak mau jalan
# lampu kedap kedip ditempat
# muncul kode error 0x00000015

Yup. It sucks pretty bad.

The ink cartridges are
not installed[1401],
or a non-supported ink
cartridge is
installed[1485],
or the ink cartridges are
not installed
properly[1687].

Check if supported ink
tank(s) is installed, and
re-install them properly,
and then close the
scanning unit.

E5
5 times
The ink cartridges are not installed [1401], or a non-supported ink cartridge is installed [1485], or the ink cartridges are not installed properly [1687].
Check if supported ink tank(s) is installed, and re-install them properly, and then close the scanning unit.

hi dear

this the error code
E9 The connected digital camera / video camera does not support Camera
Direct Printing
E14 The Ink cartridges whose destination are wrong
E15 Ink cartridge is not installed E16 - Ink remaining is unknown
E16 -E19 Failed to scan head alignment sheet
E22 Carriage error
E23 Paper feed error
E24 Purge unit error
E25 ASF(cam) sensor error
E26 Internal temperature rise error
E27 Waste ink absorber full or platen waste ink absorber full
E28 Ink cartridge temperature rise error -
E29 EEPROM error
E33 Paper feed position error
E35 15 USB Host VBUD overcurrent error - USB
E37 17 Abnormal motor driver error
E40 20 Other hardware error
E42 22 Scanner error
E2-2 No paper (ASF)
E3-3 Paper jam
E4 No ink
E5-5 The ink cartridges are not installed or a non-supported ink cartridge is installed ,
or the ink cartridges are not installed properly
E8 Waste ink absorber full, or platen waste ink absorber full




First, download the software at http://www.box.net/shared/4yblbn34kg

Secondly, to run the software your printer has to be in service mode. Do that by
- unplug cable
- press and hold "power" button
- plug cable
- press "resume" and release
- release the "power" button
At this stage, your computer will detect a new hardware

Run the software.

oke