Canon Powershot S1IS Viewfinder will not display image to be photographed. I have pressed the Display button but no success.

First you should try to press the display button the back of the camera if your model has a viewfinder. This usually deactivates the display so that you can use the viewfinder.

If this does not work then you should see if the camera plays back old images. If this also does not work then you may have a problem with your shutter mechanism, LCD display, or Image sensor.

If you camera has one of these problems the authorized service center for Canon in New York Is Photo Tech at www.phototech.com

Good Luck
Paul

Think that you might have accidentally pressed the DISP or DISPLAY button on the back of your camera. This manually turns the LCD display on and off to save batteries. You would then use the optical viewfinder in its place. To turn the screen back on, try pressing the DISP button once with the camera turned on.

Hi,

Apparently the vendor-supplied CCD image sensor used in this Canon digital camera may cause the following malfunction: When the product is used in recording or playback mode, the LCD screen and/or electronic viewfinder may exhibit either a distorted image or no image at all.

To determine if the CCD (image sensor) is working properly, follow these steps:

1. Insert a memory card with known good images on it into the camera.

2. Power the camera on to the Playback mode.

3. Press the DISPLAY (DISP) button to enable the LCD panel, and observe
the LCD.

a. If the images are displayed properly, please proceed to step
four.

b. If the images are not displayed, or a "NO IMAGES" message
appears, please ensure that the memory card contains known good images.

c. If the card contains known good images, and the issue persists
with a second memory card, the camera will require service.

4. Switch the camera to the Camera mode. You may use any shooting mode
(i.e. Auto, Manual).

5. Press the DISPLAY (DISP) button to enable the LCD panel.

6. Point the camera at a well-lit scene and observe the LCD and/or
viewfinder. If the scene the camera is pointed at appears on the LCD
and/or viewfinder, the CCD is operating properly. If the LCD and/or
viewfinder remain black, the camera requires service.

Effective immediately, and regardless of warranty status, Canon will
repair, free of charge, products exhibiting the above-mentioned
malfunction if the malfunction is caused by the CCD image sensor. Canon will also cover the cost of shipping and handling in connection with this repair.



Regards.

Think that you might have accidentally pressed the DISP or DISPLAY button on the back of your camera. This manually turns the LCD display on and off to save batteries. You would then use the optical viewfinder in its place. To turn the screen back on, just press the DISP button one more time.

Think that you accidentally pressed the DISP or DISPLAY button on the back of your camera. This manually turns the LCD display on and off to save batteries. You would then use the optical viewfinder in its place. To turn the screen back on, just press the DISP button one more time.

Try pushing the disp. or display button. I hope this helps! Please rate my answer.

Hi,
Your Canon S1IS camera has defect in CCD Sensor and Canon will repair it Free Of Cost. For details, please click Canon CCD Notice and confirm by giving call to Canon.
Regards,

formate the memory card and then try

ssue: The LCD/Electronic Viewfinder will not display an image or the image is distorted.

1. Press display (DISP.) button to turn the display on 2. If all troubleshooting has failed, please have your PowerShot A520 serviced

ssue: The LCD/Electronic Viewfinder will not display an image or the image is distorted.

1. Press display (DISP.) button to turn the display on 2. If all troubleshooting has failed, please have your PowerShot A520 serviced