How do i replace a whirlpool thin twin stacked dryer door switch

Could not find much, try links below.

TwinThin dryer element changed

Whirlpool LTE5243DQ 24 Thin Twin disassembly Google Search

https://www.google.ca/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&uact=8&ved=0ahUKEwiIkL7k4qrLAhUrmoMKHfDBCroQFggbMAA&url=http%3A%2F%2Fwww.whirlpool.com%2F-%5BLTE5243DQ%5D-1001396%2FLTE5243DQ%2F&usg=AFQjCNEsnkLT2Ac9T6mBdT3q0XplDgWH8w

Whirlpool LTE5243DQ Repair Manual Stack Washer Electric Dryer

when you open washer door you hit a stopper pin that holds the door open. there are 2 screws located around that area on both sides of panel. remove them and you'll see vent hook up and water line hook up and power cord. Now at the backside of washer door panel there are two screws remove them and pull washer door panel towards you. under the door panel connected to panel is where you will find door switch. if you jump out door switch and it works then you need new door switch.

The problem is usually not the bearings at all but the felt guides on the front of the drum. The felt wears off and then makes lots of noise. You can access this part by removing the front along with the door. Listen close with the button in and door open to see if the noise is coming from the front or rear.

I have a Thin Twin manual that will give you an idea of where to start:

THIN TWIN SERVICE MANUAL


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

first access the tech sheet and run any diagnostics it shows for the machine and if this passes,then check/change the fill switch on the control panel along with fill tube from the wash tub base if kinked or plugged

most likely it is the switch, the model # is on the dryer door once you open the door it should be on the inside of the door

My twin stacking whirlpool washer/dry. The timer switch kicks on but does not dry clothes kicks off after 5 mins but, clothes still wet.

Hello rkomita, the door switch is a NESC requirment. The model# in www.whirlpool.com/custserv/index, search for service manual. This can give the info on layout of switch location, replacement, wiring & mounting. If you attempt the repair DISCONNECT THE AC POWER FIRST. I will gladly help if you need it.

Replace the timer/control board

the thermostat might need replace