Switch wont start engine on 34 zturn mower model 74408

which model kawasaki engine?

my specialty,but,you didnt post what the problem is,so,here goes,if it wont start,it is probably a bad safety switch,take the small black wire off of the coil,if it starts,then its a safety switch,if it doesnt then it is the coil,if it only clicks with a charged battery,it is the solenoid,turn on your key and short between the two big bolts on it if it starts it is bad,if you need a belt,i will need the numbers under the seat,otherwise i will try to find them for you,i will post a user manual for you here, Murray 425607x52A 42 34 Lawn Tractor Parts
Murray 425016x48A 42 34 Lawn Tractor Parts
Murray 425306x48A 42 34 Lawn Tractor Parts
Murray 425600x48A 42 34 Lawn Tractor Parts
Murray 425618x48A 42 34 Lawn Tractor Parts
Murray 42560x52A 2000 42 34 Lawn Tractor Parts
Murray 42820x24A 1996 42 Inch Cut Lawn Tractor Parts
Murray 425619x24A 42 34 Lawn Tractor Parts
a few manuals,find yours here or go here to find it by the numbers under the seat,all part numbers are in them, Search eReplacementParts com

Yes there are two dump valves levers. One each transaxle. Location depends the model. Here is an example from a 915157.

mower over heated locked up have to force it to free up by hand turning the crank and put oil in cyclinders with plugs out turn crank by hand till loose motor is probably junk wont no till start it

bad pto switch?

there is a switch under the hand brake that you can by pass this is not a good idea but it works e-mail me when you get it [email protected]

OF course if you keep turning the engine oner,the starter is going to get hot and start smoking.Its not the battery thats the problem,it sounds like you may have a carb problem or maybe just need a new spark plug

Possible bad fuel solenoid is causing no fuel flow to the carburetor. Check fuel pump pressure if equiped. Check saftey interlock switch relays. Easiest way to test them is to replace them with 430-300 relays from stens. They arent expensive make tripple sure the fuel tank is venting and make sure the carburetor inlet needle and seat arent sticking from varnish and gum

I have a 927 series rider and just put a new battery,and spark plug.Has spark and still wont start. What else can I try?