Question about Computers & Internet

1 Answer

Mbk 320 will no longer hold power to computer is this battery related

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

You can check the battery using a voltmeter, but it sounds like it most likely is the battery. You can easily replace it by checking out for a new battery. Hope it helps

Posted on Jun 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2012 electric taotao is not holding a charge very good

The batteries on these things last around 400 charge discharge cycles. If you have recharged the bike every day for 14 months, that's it. You need new batteries - sorry.

Oct 26, 2013 | 2005 MBK Skyliner 125

2 Answers

The bike dies, after a fully charged battery.

Bike has magneito (thats spelled wrong ) On line youtube veido shows how to fix that.

Apr 01, 2012 | MBK Motorcycles

1 Answer

Hitachi 7k500-320 not detected

the drive is bad send it back to the store if you can.

Dec 12, 2011 | Hitachi Travelstar 7K500 320 GB SATA II...

1 Answer

2007 MBK Ovetto 50 loses power when accelerating

Hi, Schanachiesi and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid, installation or adjustment.
4. Clogged air filter.
5. Loose exhaust pipe at the cylinder head.
6. Missing or worn out cylinder head exhaust gasket.
7. Clogged muffler.
8. Cracked or incorrect float level.
9. Float needle is not seating.
10. CVS carburetors diaphragm faulty.
11. Gas tank contaminated outlet clogged.
12. Gas cap not venting.
13. Fuel filter clogged.
14. Faulty fuel pump.
15. Faulty reed valve.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
problems with power loss as accelerating
Loss of power on my 50cc after repair Scooter Doc Forum
OVETTO 50 Parts

Btw, I’m available to help over the phone in case u need at

Dec 07, 2017 | 2007 MBK Ovetto

2 Answers

I put coke (soda pop) on my battery posts to clean them and now when it starts I have to hold my foot on the gas. 97 Jeep Grand Cherokee limited.

It sounds like you have a brand new problem besides sticky battery posts. Make sure that you have reconnected any additional wiring to the posts. Mainly the ground wire. Usually it's a 12 guage short wire that connects to the negative battery post and connects to the inner fender well farely close to the battery. How long was the battery cables disconnected from the battery? More than 10 minutes? Most newer vehicles that have been disconnected from battery power for 10 minutes or longer after being reconnected, has to re-learn how to work or run. Fter being diconnected from power that long a time erases the memory from the computer.

Sep 21, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Averatec Voya 320 GPS Receiver won't turn on.

I had a similar problem. I removed and re-inserted the battery, and all is well.

Aug 19, 2008 | Averatec Voya 320 GPS Receiver

1 Answer


Batteries have a finite life and its not very long probably 2-3 years.
What you describe is typical of laptop computer / printer batteries.
It would appear your battery is pretty much had it.
Your answer [probably] is to buy a new one or get the one you have repacked at a battery place that does repacking.
Unfortunately battery failure is the reason many people sell battery operated portable equipment. I would never expect a battery to be any good on second hand laptops or portable printers. People have never let me down in this expectation.

Nov 07, 2007 | Zebra QL 320 Plus Thermal Printer

2 Answers

Error code messages in the status panel of the Fun! Digital 320 camera.

The following is a listing of the error codes you might see on the status panel of the PhotoMAX Fun! Digital 320 camera: 1.FL - Photo memory is full. You cannot take more photos. Download and then erase the photos in your camera. 2.FE - Flash memory error. A camera hardware error occurred. This can happen when the power is shut off before a photo is completely stored in the camera. Do not shut off the power until the green light comes back on steady after you take a photo. 3.bE - Hardware problem. Turn the power switch on and off and see if the error message disappears. If the error message persists, the camera may need to be replaced. 4.Lo - Battery low. Replace the camera battery as soon as possible. If you continue to use the camera, picture quality will be poor. 5.LL - Low light condition. The camera does not have enough light to take a good photo. Improve the subject lighting if possible. Example: When taking indoor photos, add additional room lighting.

Sep 21, 2005 | Polaroid PhotoMax Fun 320 Digital Camera

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Alun Cox

Level 3 Expert

2678 Answers

David Payne
David Payne

Level 3 Expert

14162 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides