Question about Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher
Frigidaire FDB1050REB2 dishwasher. Blinking wash indicator light when trying to start the wash cycle. Start/Cancel clears the light, but the same happens if I press the Start/Cancel button again. If the 12-pin connector to the control board is unplugged and plugged back in the washer will start if the Start/Cancel button is press. After one wash cycle the problem returns. Wiring connections appear to be sound.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ngfam1 At your service!
You plain old need service ! I am not hands on from this side of the wire!
How old is the appliance?
If the appliance is 10 years old or more you may not be advisable to put good money into bad! New applinces are so much more efficient today that they can save you a lot of money in energy!!!!
You need a hands on tech for this repair!
Below I referred you to a great service nation wide!
If none of these tasks remedy the heat problem then here is a good company that's found nation wide.
A&E Factory Service
A&E has schedulers available to take appointments 24/7
And they do warranty work too, for most manufactures!
You will be fine
Bless You ngafm1
Posted on Aug 31, 2008
your problem is most likely the aluminum wiring. Begin by running a copper line to your dishwasher eliminating the aluminum. use Romex Building Wire, NM-B 12/2 with ground and a 20 Amp circuit breaker
Posted on Oct 25, 2009
Here is what happened, you pulled the door open without pressing cancel and allowing it to pump the water out, hence the "flooding in the bottom". This is just one reason why it maybe blinking, there is a water sensor in the bottom. If your dishwasher is hooked up properly to any decent garbage disposal, run the disposal for about 30 seconds to a minute. This should pump the water out, more like activate a light siphoning affect. It should work as normal. If you are not having luck with that, detach the DW drain get it low and let it siphon.
Posted on Apr 06, 2010
SOURCE: I have a Frigidaire dishwasher,
sounds like the control panel has failed . but ck the drain pump for a plug . if it cant drain the the prosser knows and the flashing is the trouble code .. mm
Posted on Dec 05, 2010
Tips for a great answer:
Hello FJ, thank you for your inquiry!
I understand that your Frigidaire dishwasher is not working and all it does is flash the "washing" light. It sounds like a possible problem with your keypad or control panel. I would suggest performing a reset on your dishwasher and you can do that by flipping the household circuit breaker off for at least ten minutes. If that does not correct your issue I would recommend seeking assistance from a professional technician for proper diagnosis and repair. This will help you from purchasing unnecessary parts. -Matt
Jun 08, 2015 | Frigidaire Dishwashers
I appreciate your post, friend!
I understand that the clean, wash, and dry buttons on your Frigidaire dishwasher are blinking along with the four LED light. This appears to be a delay start cycle. I would recommend pressing the cancel button. If that does not clear the lights you can perform a reset and to do that you would need to disconnect power from the dishwasher for roughly ten minutes. I hope this is helpful. -Matt
Feb 20, 2015 | Frigidaire Dishwashers
Hello - Try resetting the dishwasher by disconnecting the power to the unit. This will clear most flashing lights. You can disconnect power by flipping the circuit house breaker off and back on for approximately two minutes. If this does not prove to be successful, contact a professional to move forward accurately. Dishwasher could possibly have a faulty control board or wiring failure.
Oct 10, 2012 | Frigidaire 24 in. PLD2850 Built-in...
Jun 30, 2009 | Frigidaire 24 in. FDB1050RE Built-in...
Feb 16, 2009 | Frigidaire 24 in. PLD2560LCC Energy...
Aug 14, 2008 | Frigidaire 24 in. FDB1050RE Built-in...
Jun 05, 2008 | Frigidaire 24 in. FDB1050REC Stainless...
Jun 04, 2008 | Frigidaire 24 in. PLD2560LCC Energy...
Jun 26, 2007 | Frigidaire 24 in. FDB1050REC Stainless...
Jul 12, 2014 | Frigidaire 24 in. FDB1050REC Stainless...
Apr 03, 2017 | Frigidaire 24 in. FDB1050REC Stainless...
324 people viewed this question
Usually answered in minutes!