my computer is a dell inspiron 531. 2 1/2 years old. it developed shut down problems 2 months ago....
(More)
my computer is a dell inspiron 531. 2 1/2 years old. it developed shut down problems 2 months ago. at first it would run for 4-5 days then shut down. I have replaced 1. Power supply. 2. Hard drive. 3. Optical drive. 4.Rewired ac line to larger gauge wire. 5. new heat sink and fan for the processor. Problem still exists. Only thing left to replace is the motherboard or processor. Does anyone have any clue? Please email me to cqk7yg@yahoo.com. Thanks
can you you tell me how i can fine a wedsite with a clear motherboad diagram with a step by step...
(More)
can you you tell me how i can fine a wedsite with a clear motherboad diagram with a step by step describtion of all the parts on the motherboad circuitry ?
after upgrading one of the two 512mb pc2300 ddr 266mhz with 1 gb pc3200 ddr 400mhz, computer won't...
(More)
after upgrading one of the two 512mb pc2300 ddr 266mhz with 1 gb pc3200 ddr 400mhz, computer won't boot up, has 1 long beep and has a "input not supported" msg on screen. took out the new 1 gb ddr and tried rebooting, still did the same thing. put the old 512mb back in it's original slot, but the computer still won't boot and still has the 1 long beep and "input not supported" msg. what is the possible solution to this
hi first time user my problem is i have a asrock k8upgrade-nf3 motherboard i have all the drivers...
(More)
hi first time user my problem is i have a asrock k8upgrade-nf3 motherboard i have all the drivers installed and the only problem i still have is no sound i have intalled just about every realtek driver possible for this board and still no luck it has 7.1 ch sound all onboard don't know where to go from here please help matty pavlovic
Mike solved my earlier problem with the LAN port, it seemed to have been dead until the correct...
(More)
Mike solved my earlier problem with the LAN port, it seemed to have been dead until the correct chipset driver was installed. But new problem arose with the USB port being slow. Perhaps this happens because the SP3 was installed before the chipset driver? Should I reinstall the SP3 or.... ? Thanks again, Mike !