Question about Onkyo DX-C390 6-Disc CD Changer

Open Question

Cd stuck in reading position

After taking off the top saw that the cd was being held in the read position. Draw does not open because of that.

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a cdc 675 CD changer, When I close the draw it stays close about 10 seconds, the display reads "open" and it opens back up whether there are discs in it or not


It's reporting that it (correctly or incorrectly) detected that the drawer has not fully "closed", i.e., it thinks that there was a "jam" while the drawer was sliding towards the "closed" position.

This sounds (pun intended) like you need to take the unit to a qualified audio/video technician, to trouble-shoot, and maybe check the "alignment" of the drive-tray.

Sep 30, 2010 | Yamaha CDC-675 5-Disc CD Changer

3 Answers

Cd stuck


Did you try resetting it?

Jun 04, 2008 | Bose & Wave& Music System

2 Answers

Hi my xbox 360 wont read some disks it just says 'open tray'


Hi,

The lens is out of alignment so doesn't know where the start of the disk is. This means that you wiil get the "Open tray" message with each disk you place a disk in the drive.

If you have any warranty on the Xbox 360 then i recommend that you sent it back to Microsoft for adjustment.

If there is no warranty then what you could do is lay the Xbox on its side and repeatedly tap the top of the Xbox when you put a disk in to see if it will read.

If not then you will have to take the Xbox apart which is a difficult job, then take the CD/DVD drive out. Take that apart and adjust the lens unit yourself or take the console to a repair store.


Regards.

Jul 04, 2010 | Microsoft Xbox 360 Console

3 Answers

I recieve an error code c 31 00 in my system. what do i do?


There's so much information missing from this question, but assuming this is a DVD changer, it's a disc error. Either the disc is upside-down or backwards and can't be read, is too dirty/scratched or unsupported and can't be read, or the entire mechanism is jammed or malfunctioning. If there are discs in the tray and you can remove them all, remove them and see if the error goes away. If the tray will not open, either take the cover off and remove the discs, or bring it to a service center.

Mar 17, 2010 | Sony Audio Players & Recorders

1 Answer

Xbox will not read disc. When I plug in the Xbox it powers on fine. I insert the disc and close the draw. monitor still show me the draw is open.


It sounds like your DVD drive's laser is malfunctioning. Either that or the tray is not closing all the way. You'll have to open up your console and see if the tray is stuck. If it's not stuck, it's the DVD drive's laser.

You have a few options:

1) Decrease the resistance on the laser to increase power, and it may be able to read the discs again. A guide for that can be found here.

2) If that doesn't work, or you do not wish to do that, you can replace the laser head all together. Replacements can be found on eBay. You can follow this guide to replace the laser head.

3) You can replace the DVD drive completely, but it will require taking the original drive's firmware and putting it on the replacement one. The guide for that can be found here.

Dec 10, 2009 | Microsoft Xbox 360 Console

1 Answer

My NAD cd-player has locked it self! I cannot play the cd's or even open to take the cd out. What can I do? Marit


Mine does the same. Press eject and give the front of the draw a sharp tap.. the draw should then open.
Also when loading a disk give the draw a hard shove closed just as it is almost shut - seems to make the disk read ok.
I think both problems are related to a worn / slack tray drive belt... I just haven't been able to find a replacement.

Nov 12, 2009 | NAD C521 CD Player

1 Answer

Top draw has no power


sounds like the actuator motors are stuck in the open position you can take a putty knike and try to pull the top down manually what is your email I can send you the service guide for the unit

Aug 13, 2008 | Fisher and Paykel 24 in. DD603H W Built-in...

1 Answer

Does not reconize blank CDs


this is cd reading problem so open ur cpu and see the bus connection in between motherboard to cd drive....
and replace the bus.....

Jun 02, 2008 | HHB CDR850 CD Recorder

1 Answer

Cd does not read every time


I love Marantz! They make quality products that last and sound excellent! Most likely it a dirty lens. When a lens gets dirty, it can't read the cd as accurate. Unplug it, remove the cover, locate the cd lens take a q-tip lightly dipped in rubbing alcohol and rub it lightly on the lens (don't drip it too wet). This should help. Sometimes they also have a weak laser which can cause the same problems, but try the cleaning first. 

Apr 23, 2008 | Audio Players & Recorders

Not finding what you are looking for?
Onkyo DX-C390 6-Disc CD Changer Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onkyo Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5011 Answers

The Knight
The Knight

Level 3 Expert

73619 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Are you an Onkyo Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...