Question about Car Audio & Video

1 Answer

How to wire in a kenwood KDC-U456 to a xf falcon ute

Wiring in ute dash not color coded same as sterio cd unit

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 112 Answers

If you don't have a schematic on the old radio the only way to be sure is check it with a multimeter , first identify your permanent power 12 volt DC then find your switched 12 volt this will turn on ansd off with your ign key , the earth cable is normally slightly thicker than the rest of the other wires in the loom and will normally be black or green yellow , you wil need to set your meter to ohms setting to identify the speakers you should get 3.8 to 4 ohms reading back from the speakers when you find them.

Posted on May 03, 2014

  • MERV BEARD
    MERV BEARD May 04, 2014

    mossman 12, thank you very much for your time and help.

  • MERV BEARD
    MERV BEARD May 04, 2014

    mossman i

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 37 Answers

SOURCE: need to find rear speaker wiring in bf falcon ute

rear speaker wiring usually can be found at the front and traced to the rear of the vehicle but most common place would be to check at the back already at sidewalls or the backboard.

Posted on Sep 14, 2009

Benimur
  • 6966 Answers

SOURCE: need wiring diagram for kenwood

Hi,

To my knowledge most Kenwood head units uses the following wiring/color scheme:
Yellow - always on B+12VDC such as the positive terminal of the battery;
Red - switched B+12VDC such as the ACC terminal of the IGN switch;
Black - Ground/chassis;
Pink - not available
Brown - mobile phone mute
Blue - power antenna
Blue / White - remote trigger for external device
Pink / Black - external amplifier control wire
Gray - Front Right +
Gray / White - Front Right -
White - Front Left +
White / White - Front Left -
Purple - Rear Right +
Purple / White - Rear Right -
Green - Rear Left +
Green / White - Rear Left -

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 02, 2008

tech48
  • 624 Answers

SOURCE: Kenwood - KDC-1020, Service Manual or

This is the standard Kenwood wiring harness from the service manual,
Let me know if you need more help.
I would appreciate a good rating if this was helpful to you.
Thanks
95bf658.gif

Posted on Jun 20, 2008

logosc75
  • 625 Answers

SOURCE: Wiring schematics for a kenwood

Battery light green to yellow
Accessory yellow/black red
ground black black
Illumination light blue.red orange/white
Power antenna amp=blue blue
LF + orange/light green white
LF - light blue/white white/black
RF + dark green/orange gray
RF - white/light green gray/black
LR + gray/light blue green
LR - tan/yellow green.black
RR + orange/red violet
RR - brown/pink violet/black

Posted on Sep 21, 2010

  • 250 Answers

SOURCE: Replacing the Eurovox cd player/radio

Do you have a wiring diagram for the Pioneer Unit, or is this the one you want the diagram for ? Get back to me with a bit more details, e.g. have you got a diagram for the Eurovox? Have you pulled out the Eurovox yet? (I hope not ).

Posted on Jul 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenwood kdc-x399 troubleshooting


Check Kenwood wiring color code and function against vehicle harness color code and function. They are not always the same.

Aug 03, 2016 | Kenwood Car Audio & Video

1 Answer

No sound.


The first thing you need to do is doublechecking all the new wirings, it sounds like a contact.

Oct 24, 2008 | Kenwood KDC-MP338 Car CD Player

2 Answers

Swapped it from XF falcon to a triton ute and cannot get it to fire up.Any suggestions?


if it is a radio , you will need an unlock code because disconnecting it from a power supply activated the anti theft system in the radio

Dec 10, 2015 | Pioneer DEH-235 CD Changer

1 Answer

I lost the wiring color codes for my kenwood KDC-MP628 CDReciever


http://www.tehnomagazin.com/Auto-radio-car-connector/KENWOOD-Car-Radio-Wiring-Connector.htm for the deck
.
1) Remove the ashtray and the two outermost screws exposed in the ashtray cavity.
2) Remove two screws from each side of the dash console.
3) Remove the climate control knobs.
4) Unclip the trim bezel and remove.
5) Remove four screws securing the car stereo to the dash.
6) Pull car stereo from console releasing antenna and connectors.

Constant 12V+ Red Switched 12V+ Orange/Yellow Ground Black Illumination Red/Green Dimmer Green/Red Antenna Driver's Pillar Front Speakers 6 1/2" Doors Left Front (+) Orange Left Front (-) Black Right Front (+) Gray Right Front (-) Green Rear Speakers 4" Tail Gate Left Rear (+) White Left Rear (-) Red Right Rear (+) Yellow Right Rear (-) Blue

Jun 16, 2009 | Kenwood KDC-MP628 CD Player

1 Answer

Need color codes for a kenwood kdc- 122p head unit in dash.


Hi there,
Generally you can find these manuals freely available at the manufacturers website, however it usually take ages worth of searching and i thought id save you the hassle,
Head to this link for your units entire manual.. Page 17 i think it is exactly.
http://www.cartoys.com/cartoy/pdfs/kdc-122s_manual.pdf

There a good little unit but sold a few when i was working in the industry.

Otherwise generally you can pick up pre wired pugs that adapt the cars harness via one plug to the back of the stereo avoiding any splicing. If youre interested in them head to this website,

http://www.aerpro.com.au/contents.php?menu=Harnesses

Hope this helps, 
Have a happy easter
Cheers
Steve

Apr 03, 2009 | Kenwood KDC-122 CD Player

1 Answer

Installing kenwood cd player in EF ford falcon


this is not a sales pitch but i purchased the correct patch harnass from pmr, it should be available at any good sterio store for about $10

Mar 17, 2009 | Kenwood KDC-MP4028 CD Player

1 Answer

I need the wire colors and what they are for for my kenwood kdc-205 car sterio


Here is a link to the manual which has the wiring and all the installation instructions in it.

http://inform3.kenwoodusa.com/manuals/KDC-205.pdf

Mar 04, 2009 | Kenwood Car Audio & Video

1 Answer

Kenwood car radio/cd player Model No KDC-3027


Do you like need the colors codes for the harness like speakers and and all?

Nov 19, 2008 | Kenwood KDC-3027A CD Player

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4861 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

The Knight
The Knight

Level 3 Expert

74243 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...