Question about Dryers
I need to repeat the commissioning process on a new Miele PT 7136, the manuals all state this has to be done by a Miele Technician but the dryer is installed on a boat in the middle of the Pacific. It must be possible for me to repeat the commissioning!
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It differs from product to product
I would sujjest first you choose a product for a base station installation and commisioning and then read their manual
This way you can learn
Posted on Feb 24, 2008
SOURCE: Miele Dryer heater bank
i am sending you all the possibilities for your problem, check either of these causes ----and than let me know if it is solved----
Power from the house
Check to see whether there's power getting to the dryer. Is it plugged in? Check for blown fuses or tripped circuit breakers--your dryer uses two fuses or circuit breakers. The dryer could tumble but not heat if only one of the two fuses is blown. If you have circuit breakers, one of the two circuit breakers can trip, even if the two for the dryer are connected.
Often a dryer heating element burns out, but doesn't trip the circuit breaker or blow a fuse. The heating element is simply a long coil of special wire. You can check it for continuity with an ohm meter. No continuity means the element is bad and you need to replace it--electric heating elements aren't repairable.
On many dryers, there's a thermal fuse mounted to the exhaust duct inside the back cover panel. The fuse--which is about an inch long--is usually embedded in black resin and mounted in a white plastic housing. If the fuse has blown, you need to replace it. (You can't re-set it.)
A common problem is for the main wiring connection from the house, at the dryer, to burn and break its connection. Because the dryer can still tumble with partial power, the connection may be only partially defective. You may need to replace both the power cord to the dryer and the terminal block inside the dryer that the wire is attached to.
Posted on Dec 26, 2008
Tips for a great answer:
May 12, 2014 | Sewing Machines
May 06, 2011 | Computers & Internet
Sep 11, 2010 | Heating & Cooling
Aug 07, 2010 | 2001 Oldsmobile Alero
May 17, 2010 | Computers & Internet
Jun 28, 2009 | Nokia Consumer Headset
Feb 16, 2009 | BafoTech BAFO BF-1284 Parallel Adapter
Oct 21, 2008 | Computers & Internet
Feb 23, 2008 | Computers & Internet
35 people viewed this question
Usually answered in minutes!