Question about Taylor Digital RefrigeratorFreezer Thermometer

Open Question

Thermometer reads LL

What does LL mean

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instant dig read thermometer shows LL and I can't get a reading


LL means that the sensor is below the rated temp It could be a bad sensor.

Apr 11, 2017 | Home

1 Answer

Thermometer is reading HH. What does this mean???


Thermometer on WHAT? What type of device are you looking at? Also a model number would be super helpful if you can find one.

Mar 20, 2017 | Home

1 Answer

It says LL under current temp. What does that mean


That means that sensor believes the temp to be LOWER than it can read. Could be a bad sensor. If there is a reset button on the sensor use that to reset the device.

Sep 23, 2013 | Taylor 1479-21 Digital Thermometer

1 Answer

Infrared Ear thermometar ET-100B


the L means either the temp u took is to low to read or u need to replace the batteries

Aug 10, 2013 | Prestige Medical Infrared Ear Thermometer

1 Answer

The digital thermometer was flashing "lo". I assumed it needed new batteries and then replaced them. It is still flashing lo, but also showing a C reading. What do I need to do to reset it?


there should be a setting on it that changes the temp from Celsius or "c" to ferinheight and lo means that it currently isn't reading a temperature in the normal range. try running it under hot water and see if it says error or high.

Jul 15, 2011 | Prestige Medical Infrared Ear Thermometer

1 Answer

Grill will only heat to 350 degrees


I suspect the problem, is a result of either dirty and/or clogged burners and venturi valves (part of the burner). Or the grills gas regulator is partially locked close.

Since the regulator problem does not involve any real dismantling of the grill, I'll start with that solution first. The most important thing is - Do you have enough gas in the tank, for the grill to perform as it should? If it was recently filled, do the following.

1. Turn the gas valve on the tank OFF.
2. Disconnect the hose from the tank and wait 5 minutes.
3, Reconnect the hose to the tank and turn the tank valve ON, VERY, VERY SLOWLY (Slow
Motion, slow)
4. Once he tank valve is fully open, light the burner farthest from the tank first and turn the burner
knob to HIGH. Dose the flame height look correct? If so, light the remaining burners the same
way, until are are lit and burning. Do all the flame heights look correct when set on HIGH? If so,
you solved the problem. Close the grill's hood and allow it to heat in excess of 350 degrees. It's a
good idea to confirm that the thermometer on the grill is accurate. Place an inexpensive Oven
Thermometer (about $6.00) that will set on the grill grate(s), while you preheat the grill. When the
grill's thermometer reaches 350, raise the hood and compare it with the reading of the oven
thermometer. if they read approximately the same, then your grill thermometer is accurate. If the
oven thermometer reads higher, the grill thermometer needs to be replaced. Frankly, mind failed
to read accurately. Rather than replace it, I always use the oven thermometer, because it's not
reading the air temperature at the hood level, it's reading the temperature at the cooking level.
Which is really what I want to know.

If the above did not solve the problem, you will need to replace the grill's Hose/Regulator Assembly. You can purchase one from any home center or hardware store that sells gas grills and accessories. They run about $30.00. Take you old one with you for comparison purposes.

Hope this helped you troubleshoot and solve the problem. Please let me know and Happy Grilling!!

Jun 17, 2011 | Ducane 30400040 Stainless Steel Grill

1 Answer

The thermometer turns red when i turn on my car, it's normally blue.. what does that mean


That's totally normal, that's just the sensors in you car making their self tests while starting the engine to ensure that they are working ok. It's just testing that the coolant temperature warning system if working ok, hence the red thermometer appearing. After that all the systems go back to normal and give you their true readings, and that's why it goes to blue, which means the engine is cold and just started. After a while when the engine heats up normally and has run for a few minutes, the thermometer should disappear completely. My 2005 toyota echo does exactly the same thing, and so do many newer vehicules. So nothing to worry about, it just means everything on that system is working fine and like it should.:)

Jul 08, 2009 | 2003 Volkswagen New Beetle Convertible

Not finding what you are looking for?
Taylor Digital RefrigeratorFreezer Thermometer Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Taylor Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4654 Answers

yadayada
yadayada

Level 3 Expert

75030 Answers

Brian Coughlan

Level 2 Expert

275 Answers

Are you a Taylor Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...