System not fetching code - HP Compaq dc7700p PC Desktop

The Fetch automatic remote setup for a Soniq TV also worked with my older JVC TV, no code needed.

You cannot hot swap HDMI connections. First thing to try is to power off and unplug all the devices from everything. Then make the connections to the Fetch and the Television, Then power to the Fetch, then the television, then turn on the Fetch, then the television. There is also a chance that the HDMI cable is an older one and needs to be replaced.

Outlook emails only work with IE on the 'web server' - you could install and use a mail fetching program (which is what Outlook actually is), or you can use IE to fetch the mail.

Have u installed the new hardware on the desktop ?

Forget the fetching from the camera...pros never use that method because of problems such as you are experiencing. Instead, use a card reader to download the pics from the card to a folder you create on the desktop. Once there, you can send them to any program you like.

Here is the solution:

Beeps 9 times:- System not fetching code Microcode

"update" else replace the system board

That deals with your bios.

I would try resetting the CMOS first.


More on fetching code:

http://en.wikipedia.org/wiki/Power-on_self-test


To clear CMOS:

<quote>

Clearing CMOS*
The computer's configuration (CMOS) may occasionally be corrupted. If it is, it is necessary to clear the CMOS
memory using switch SW50.
To clear and reset the configuration, perform the following procedure:
1. Prepare the computer for disassembly.
ã„CAUTION: The power cord must be disconnected from the power source before pushing the Clear CMOS
Button (NOTE: All LEDs on the board should be OFF). Failure to do so may damage the system board
2. Remove the access panel.
3. Press the CMOS button located on the system board and keep it depressed for 5 seconds.
4. Replace the access panel.
5. Turn the computer on and run F10 Computer Setup (Setup-utility) to reconfigure the system.
*When the CMOS button is pushed or the jumper is removed, both the power-on password and the setup password

<end quote>

Your error code page:

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00219460/c00219460.pdf


PC homepage:

http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp?lang=en&cc=us&prodTypeId=12454&prodSeriesId=402163&lang=en&cc=us

Please rate me if this helps

Andy

Hi Tulsi,
offcourse you can do it. But for this you must have knowledge of assembly programming, so that you can embed ASSEMBLY CODES in a C program using following way:-

ASM:
assembly codes

Alternatively you can fetch code simpling by opening and observing corresponding header files (system.h etc.) in a text editor like notepad.

you can refer to LET US C (Yashwant Kenetkar) for details.

for specific code you can contact me.

Thanks

Zulfikar Ali
[email protected]
09899780221