Question about Sony 900mhz Baby Monitor

Open Question

Sony 900mhz baby reciever lights work when there is noise but nothing comes through the speaker.

Monitor was bought used. It was charged for 24 hrs. It is set on the on position. When there is noise made the indicator lights light up like they should depending on how loud the noise is. But nothing comes out of the speaker. What could be the problem?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MikeNJ1964
  • 398 Answers

SOURCE: Loud bang, unit stopped working

I have seen the caps in the power supply vent, which means they get hot and the top pops up and splits open, resulting in the "bang" sound. If you have experience in electronics then remove the back of the set and examine the power supply, looking for any caps whose tops are bowed upward, and replace.

Posted on Jun 28, 2007

leecom72
  • 4806 Answers

SOURCE: PCG-8P3M starting problem

Hi there
plug an external monitor to the laptop to rule out the inverter
post back

Posted on Jan 21, 2009

  • 2 Answers

SOURCE: stand by light blinks tv does not turn on

how can i solve thjs problem?

Posted on Jun 22, 2009

SOURCE: My ps3 wont power up

try powering the system up by HOLDING the on;off button , it will reset all your audio and video settings . then plug the system using the AV cables (default) .

else, you should take it to an assastance centre for hardware issues checking . can be a problem with your RAM or GPU units that makes the system unable to startup it's firmware .

Posted on Jul 27, 2009

  • 68 Answers

SOURCE: 900MHZ CHARGING LIGHT STAYS RED AND DOES NOT GO OFF

Didyou try taking the battery out of the headphone and replacing it? This may act as a reset and allow charging. I'm assuming that these headphones are not brand new, and that you are lining up the arrow on the one side with the arrow on the charging base. This is the only way the inductive charging can occur. Good luck!

Posted on Jan 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My audio coming from monitor and other speakers has a rasberry or grinding noise most of the time


Looking at the HP Support page for Software & Driver Downloads, I don't see any audio drivers listed, for ANY of the Windows operating systems,

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?os=4063&lc=en&cc=us&dlc=en&sw_lang=&product=4329389

Driver: Small piece of software that allows the Operating System to communicate with a device

The device is the audio (Sound) chipset.
Do not know what the O/S is.

You have corrupted audio drivers.
What leads me to this conclusion is you have noise on your computer speakers, AND monitor speakers.

If it were just computer speakers, per se, I would say they are bad.
Or if it were just the monitor speakers.

Since there are no audio drivers listed, this means to me you need to obtain the Restoration Disk; if you do not have it.
(And I mean disk IN hand; not download from the internet)

Using the USA as an example;
The disk is free. The shipping and handling is not.
$17 for a 5 to 7 day ship; $24 for a 2 to 3 day ship.
Call 800-474-6836, 24 hrs a day, 7 days a week.

Have the Serial Number written down, to give to the nice representative. This is found in the white Service Tag, on the back of the computer.
S/N = Serial Number

For other countries use HP Support Worldwide,

http://welcome.hp.com/country/w1/en/support.html

Install the disk in your optical drive.
When asked choose - Repair. (Non-Destructive Installation)

Regards,
joecoolvette

Jan 04, 2013 | HEWLETT-PACKARD Hp Pavilion Elite Hpe477c...

1 Answer

Sony camera not charging


is the battery old , if not you could have a defective battery, you need to test battery or take to place you bought it and have it tested, try this if battery old, take a small piece of fine sand paper and scuff the copper ends of battery very lightly, use a cloth to clean, reinstall in camera and try to charge if there is no charge, good chance battery is defective, note *** battery will take approx,6-8 hrs to charge if old , new approx 12 hrs hope this works,,

Oct 02, 2012 | Sony Cyber-shot DSC-S980 Digital Camera

2 Answers

Out of nowhere we get cracking it just started happening went on all night. tried everything figured we needed a new monitor got a new one and its still doing it help we love this monitor


Sounds like interference if its battery opperated try switching of your house electricity to see if it goes away, if it does turn everything back on one at a time until interference comes back, then by process of elimiation find the culprit.
I would be looking at items that use any sort of radio frequency, wireless devices, cell phones and wireless house alarm if you have one.
If monitor uses a power supply try batteries instead to see if that makes any difference, try a different power supply.

Sep 29, 2012 | Sony 900mhz Baby Monitor

1 Answer

Beeps out of range when there are batteries and the ac adaptor is plugged in


Transmitter is in range and plugged into the wall and still keeps beeping non stop. Can you tell me what seems to be the problem?

Jul 01, 2011 | Sony 900mhz Baby Monitor

2 Answers

My range alarm keeps going off on my sony baby monitor when still in range. how do i fix this?


I took the battery pack out and just used it plugged in. The only problem is the voice activation setting doesn't work. Not sure why it would work on the other setting and not this one? It did quit beeping and crackling though.

Apr 27, 2011 | Sony 900mhz Baby Monitor

2 Answers

Why does the monitor continuously beep? It has a


I realize this original post is old, but just incase someone is looking for solutions, I will put what worked for me. I have the T4841, and had the same problem. No matter how close or how charged the battery, it kept beeping saying out of range even though it was only a week old. I got it to work by pushing the reset buttons on the monitor and receiver at the same time. The reset button on the receiver is on the back (tiny hole with black button - a pen tip fits nicely). The reset on the monitor is on the left side just about halfway up - right below the light button. Hope this helps!

May 16, 2010 | Fisher Price Long Distance 900mhz Baby...

1 Answer

How to hook them up by the lake


By the look it is wireless. It should come with something to attach to the amp for the signal. It should work fine.

Jun 17, 2009 | Cables Unlimited 900MHz Wireless Rock...

4 Answers

2003 Phone- no dial tone GE CORDLESS 900MHz


I am having the same problem with general electric model 27939ge3-a . I am very displeased with the GE website(s) as it is difficult to manuveur around to find any user manuals.

Next time I purchase a phone, I will check the manufacturer's help support first.

As to a solution. I may try purchasing a new battery. Perhaps it is a power issue

Oct 30, 2007 | Uniden Cordless Phone

Not finding what you are looking for?
Sony 900mhz Baby Monitor Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Baby Gear Experts

kakima

Level 3 Expert

102366 Answers

Owen Barnes

Level 3 Expert

867 Answers

Dorel UK
Dorel UK

Level 3 Expert

1629 Answers

Are you a Sony Baby Gear Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...