Door open error - HP Officejet 6310 All-In-One InkJet Printer

The Autoclave door is not opening at the end of the cycle.

Midmark M11 "Old Style" Error Code E009

Sterilizer Autoclave Solutions https://statimusa.com > midmark-m11-old-style-error-...
Error E009: Door doesn't fully open at the end of a cycle. This error indicates that there is pressure buildup during the dry cycle. Probable causes of Midmark ...

Error Code E009 :

AllClaveParts https://www.allclaveparts.com > error-code-e009
You will need to know whether or not the Door is Opening Automatically at the End of the Cycle when you get the Error Code E009 before proceeding.

• 
  

  E009 - Door Does Not Open At End Of Cycle :

  https://www.allclaveparts.com > error-code-e009 > e0...
  Midmark M9 & M11 Error Code E009 Door Does Not Open At End Of Cycle · Remove any debris or buildup from Latch Lever & Pulse Solenoid Mechanism · Remove burrs; ...

it will be from cover sensor or Main board

When you see the DE error code, it means a "door error". This is a sign that either the door is not shutting, locking or opening. Most of the time, this is a simple fix and service is probably not needed. Check for something stuck or lodged in door. Check door gasket. Check door latch.

If your garage door is up, and you break the beam (by walking through it, for example), you will get the "SENSOR WIRING INTERMITTENT CONNECTION ERROR CODE 1-4 SEE USER MANUAL". This is normal. Both of my Liftmaster 8550 openers do this. It's misleading, but this is what I've found to cause this error.

pront door liver switch open not work it ,or it displace.you should check it or service need

This error code indicates that the door needs to be opened and closed.

The F26 code may appear the first time you try to use the washer. Open and close the door to clear the display.

The F26 code may also appear if the washer has run three cycles without the door being opened. Open and close the door to clear the display.

If opening and closing the door does not remove the error display, press Pause/Cancel twice

Error: "Rear access door open" (3514)
How do I resolve the error message "Rear access door open" (error code 3514)
To clear the "Rear access door open" error message:

1. Remove the rear access door from the printer.
2. Reinstall the rear access door on the printer and verify that both latches are securely engaged.
3. Unplug the AC adapter from the printer.
4. Plug the AC adapter back into the printer.
5. Wait for the printer to initialize.
6. Verify that the error has cleared.

DOOR SWITCH ERROR

If the door has not been opened for 3 consecutive cycles or the door switch is open while the door is locked for more than 5 seconds.

Possible Causes/Procedure

-Door not opened during 3 consecutive cycles.

1. Open and close the door.
2. Verify CCU operation by running a Diagnostic Test or any cycle.

-Door switch open while door is locked.

1. Push the door and check if it is completely closed.
2. Verify CCU operation by running a Diagnostic Test or any cycle.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.$$$$

the door you open to put the cartridge. If the door is closed and you still get the message, it means the door is not activating the microswitch when the door is closed. There must be a tab on the door which presses the switch.

I Have had the same problem. I changed the power supply an the error was never detected