Question about Intel Computers & Internet

Open Question

Bios settings in windows vista system

Blast is nesesario Reset the mother or change the same settings but I can not enter please tell me how.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
habib_101
  • 55 Answers

SOURCE: bios reset

As another option you could try resetting the jumper. Some boards save the password regardless unless the reset the BIOS by using the resetting jumper. Refer to the motherboard's manual for further information on how to do this.

Posted on Oct 10, 2006

Ad
  • 39 Answers

SOURCE: How to go to boot settings in IBM 6578-PBU machine

Try each of the following: F1 F2 ESC DEL F10

Posted on Aug 26, 2007

biigg53566
  • 81 Answers

SOURCE: remove vista

to change from windows to XP this is change of the operating system, it is not a simple change of a setting. you are best to find a good knowledgeable person who knows what he is doing, other wise you could ruin your hard drive and have nothing

Posted on Nov 28, 2008

greg_margo
  • 1959 Answers

SOURCE: Broke system while attempting to overclock with AMD Overdrive

Found this on Biostar's support page:

http://www.biostar-usa.com/knowledgespec.asp?faqid=99977

They recommend unplugging the power cord for 5 seconds. After plugging back in, press and hold the "INSERT" key when booting to reset the CMOS back to factory defaults.

Since you were never able to actually boot with the overclocking, it's doubtful that any damage has been done especially since the MB shut itself down as a precaution.

Best of luck!
Greg

Posted on Jun 13, 2009

Damilare
  • 358 Answers

SOURCE: i have hp dv4-1465dx, how to reset bios without having OS

Hello,

Was Windows 7 the operating system that came with

your System? If not, What I would advise you to do

is this:

Check HP website to find out if your Laptop supports

Windows 7.

If it doesn't, then I would advise you to

PLEASE change it back to the operating system

that came with your system, or better still, the

operating system that it supports.

The reason is because that is exactly what I faced

two weeks ago....

I changed the operating system for my PC to

Windows 7 ( Even though it doesn't support it)...it

worked fine for a while, then later it started to develop

faults after a while...like stuttering, mouse pointer

moving round the screen, graphics displaying

improperly...etc.

I first thought it wasn't a big deal, so I fixed it by

repairing the drivers, and it worked fine once again...

After using that same crack that you said you used,

I started getting "Multiple Hardware Error"!

It would just Power on, Show HP Logo, Show

Wireless LAN indicator Led ON, and It will freeze

there. I could not even enter the BIOS.

In short ....Now as I'm typing, the system is

with HP Service Centre for they have to change the

Mainboard Outrightly!

So PLEASE, if your system was not specified

Windows 7, use the Operating Systems that it

supports.

Then go to HP Website and download the original

BIOS settngs for your Laptop then repair your

system with it.

But if it is the one that came with it, then let me know

so as to tell you some quick fixes.

Hope this helps you out.

Goodluck and thanks for using fixya!

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dear Guys,Windows Vista is very slow.


well first of all vista is slow and ur system may be a bit to old for vista, but thats cause vista is stupid, see vista will do ten things to do one thing! make sense see vista is just a pretty version of xp, Your computer is fast but also you installing a horrible OS on it, just stick with XP man unless you really liked vista then just a newer computer will solve this, just stick to XP.


LOL ok 2 GB harddrive haha ur Operating System is at least 9 GBS lol maybe you meant 20 lol

Oct 28, 2009 | Microsoft Windows Vista Home Premium with...

2 Answers

I forgot the security password


here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user password

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.

Aug 08, 2009 | Acer Aspire 5580 Notebook

1 Answer

Need help forgot password for HP Compaq NX7330


here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user passsword

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.
Please rate me .
Thanks .

Jul 29, 2009 | HP Compaq nc6320 Notebook

2 Answers

Hdd password


my laptop has been in storage for 14months now i switch it on it asked me for a hdd password it never did b4

Jul 25, 2009 | Acer TravelMate 3260-4874 Notebook

1 Answer

D520 setup locked, cannot change boot order or re-install os


here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user passsword

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.

Jul 24, 2009 | Dell Latitude D510 Notebook

1 Answer

Hts541680j9s wont take password


here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user password

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.

Jul 24, 2009 | Acer Aspire 5720-6661 Notebook PC

1 Answer

Compaq c-series 2010c unlock utility code


here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user passsword

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.

Jun 18, 2009 | Computers & Internet

2 Answers

Hard drive locked


First check in bios that your harddisk is detected or not?

You can ente rin bios with following method:

When u powerup press F2 or "del" F1 key to enter in bios.
but if u have problem of bios password followbelow procedure

here are 2 password type first 1 is bios password if tell me about your bios password it prompt when u powerup follow procedure below

For that you need to reset factory defaults settings for bios.
For reset bios u have to open back side of your laptop then u find motherbord circuit there.
pull cmos cell on motherbord for 15 minute then it reset to defaults.
Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios reset or clear"
It is on 1-2 position right now set it in 2-3 position then power up then all bios settings are reset.
then again set it in 1-2 its original position.
Then it not want password.

And if u tell about windows password
Then when you power up the computer press F8 key then enter in safe mode then wait until it prompt for user passsword

then enter in administrator then if u able to enter then reset your password.
But if u set and forgot default administrator password then u should need winxp recovery disk.

Jun 15, 2009 | ASUS M5N PC Notebook

1 Answer

Gateway laptop forgotten password operated by Windows Vista


Dear snmo7


You May be able to reset or turn off the password using your bios settings in dos mode.

To access your bios settings ,turn on your Laptop & hit the delete key repeatedly untill the bios settings menu is displayed.

Use the <-- --> arrow keys to scroll through menus and locate the Password options . You should have the option of reset/enable/disable the system/supervisor passwords..
Exit Bios saving the changes..

Jun 18, 2008 | Sony VIAO P4 PCV-RS712 3.0GHz 512MB 200GB...

5 Answers

How to repair mother board in chip level


board has getting on but desply not come and cpu surrounding componant not get power

Jan 20, 2008 | ASUS P4BGL-MX 845GL (AS04P4BGL-MX)...

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Intel Computers & Internet Experts

Tony

Level 3 Expert

2600 Answers

David
David

Level 3 Expert

781 Answers

vsri9

Level 2 Expert

73 Answers

Are you an Intel Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...