Question about Televison & Video

2 Answers

Curved picture everything ok sound and picture wise. The picture on eack side is curved inwards. The curve starts at the top of the screen coming in at the middle aprox 3 inches then curving back down to the bottom corner. It is like looking at a woman with an hour glass figure. But only showing the waist area.

Posted by on

  • martini32 Nov 14, 2007

    Many thanks. Do you have any idea where I can obtain circuit diagram for this set please. Regards. Raymond.



2 Answers

Soldered the diod connections on mine,it did the trick, sometimes its just a weak connect[older 1996 GE 32]

Posted on Feb 16, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 93 Answers

Ur problems is on the pincushion check for a capacitor that its bad on the pincusion section  good luck.

Posted on Nov 01, 2007


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a Phillips 60" rear projection TV. recently

Tv have a problems known as a convergence problems,it is dead.The tv convergence board it is dead,that why ur tv picture are R,G,B colors lines mis alignments,have colors shadows picture or 3D picture lood alike?The tv convergence board require changes 2 STK convergence ICS and some or all of it resistors too.To fixed the tv convergence board to solved the tv convergence picture problems.The shop will cost u like $300-350 for parts and labors.

Jun 01, 2011 | Philips Televison & Video

1 Answer

Fujifilm s1730 when i take a picture the buildings on the outside of the picture curve inwards and are not vertical as it should be

When shooting wide angle pictures (as you would be doing when shooting buildings) the sides of the pictures will curve inwards...the wider the angle, the more pronounced the curve will be. This is perfectly normal.

Oct 01, 2010 | Cameras

1 Answer

Poor picture quality. Picture also tends to curve

The curving is caused by bad digital convergencr chips (2) located on large signal board. They need replaced along with blown pico fuses and the convergence resistors. Chips are huge compared to a regular IC. 2" x 1.5" and they will be bolted on fairly large heatsinks. Cloudy picture is most likely the coolant needs replaced in the picture tubes. This needs to be done approximately every 5 years.

May 01, 2010 | Philips Magnavox 9P6034C 60" Rear...

1 Answer

I have a Samsung HL-T5676S DLP TV and the picture just recently started to look curved. In the middle of the screen it's straight but on the sides it starts to curve up. Any idea of what could be causing...

make sure you do not have anything sitting on the top of this tv. I have seen this on my tv by just gently putting pressure with my finger on top the screen starts to curve up at the edges.

Jan 14, 2010 | Samsung HL-T5676S Television

1 Answer

My samsung cr32z30 32" hdtv turns off automatically after running for about 30min to an hour. also the picture is curved on both sides when watching tv in 4:3 ratio. the curve is most prodominate at...

Linearity coil (there are several) shorted causing HV to increase and causing HVSD, no replacement parts available. Replace sweep module to fix.

Nov 10, 2008 | Samsung Televison & Video

1 Answer

Picture curves inward and i see at least 3 of everything

it will cost about 350.00 to repair it if you find a good sounds like the convergence board went out

Aug 17, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Mitsubishi VS-4561 picture curved inward

Its Your Convergence Chips!. And Maybe a few Resisters!. Common Problem with this kind Of Set!.....

Jun 30, 2008 | Mitsubishi VS-45607 45" Rear Projection...

1 Answer

RCA Projection TV model #p61926

The convergence circuit is your problem and most times with this model the convergence power supply bd. is the problem.

Feb 11, 2008 | RCA P46921 46" Rear Projection Television

1 Answer

Screen is curved inward on all 4 sides and there is a red, and a blue line that is curved at the top of the screen

This is a convergence problem.. possible deflection problem... you might need a tech to look at it...

Nov 19, 2007 | RCA HD56W66 56" HDTV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75025 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Cindy Wells

Level 3 Expert

5302 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides