How do i adjst the f my hotpoint wf860 washer.nothing happens when i turn them

get some descaler part No C00090908 that should sort the smell as for the seal you will better off replacing it

the problem with small loads is that the tub gets unbalanced very easy,if it spins correctly with a larger load there's nothing wrong with the washer,it's just unbalanced,you can open the lid and move the clothes around by hand to try to balance out the load,very common,also has the washer been moved?check for level,if it was moved one of the legs could have moved to put the washer unlevel,

Washer may not be level, try adjusting the front feet down a bit to raise the front of the machine as it may be leaning forward slightly.

could b presure system blocked up find this on side of filter long plastic *****

You might need to check if it is level also that if all the feet are stable on the floor. if all this is fine it is probably the suspension witch is on the way out and needs replacing. hope this helps

f12 is an electrical connection problem between the 2 circuit boards of the machine. it may be a loose connection or more likely a new power board required.

Taken from another post - just happened to me 5 mins agao so not fixed yet!......now showing F-01 (motor triac short circuit).....

F-08 heater relay stuck check pressure switch, heater and module connections poss pressure switch fault

Good luck and let me know if/when it's sorted as may give me an indication of costs etc

Hiya got it sorted on my machine, it turned out that the out pipe was blocked. Hope this helps

Vikki

Firstly try making sure that all the feet are tight to the floor, and that it is failrly even... also that it is free of any impedement to the sides of the appliance ..this should sort it .. let me know if it does please!

regards Faggly

poss uneven floor try adjusting the feet at the front