Question about Toys

Open Question

Rc helicopter h806 1/c inside it a red light is blinking and not taking off

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: My new u-control helicopter is experencing spinning

I had the same problem, the helicopter would spin out of control and the trim did not help. I took a closer look and noticed that only the top rotor was turning. I took the bottom off of the round gear box to find a tiny white gear had slipped off the second motor. With a pair of needle nose tweezers I was able to reattach the gear and I was flying in no time.

Posted on Feb 02, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Gyro s107g helicopter won't connect to the remote. It just sits there not moving or any lights turning on.


It sounds like the two are not compatable. In other words the freakwinsy of the plane is not the same as the controller. THEY MUST MATCH. You may find the numbers on the back of the controller and where the batteries go in the chopper. If the numbers do not match, take it back to the store, and get one that does. Sorry for the spelling

Jan 13, 2015 | Syma S107G 3CH RC Helicopter RTF w/ Gyro...

1 Answer

My v913 helicopter took a little crash to the front and now my controller wont connect to my helly the red light on the helly used to blink to link up but now it just stays solid red


sorry Kyle but you're going to need a new circuit board for that the 913 it crashed and must have cracked or something so you can have to change hair a circuit board

Jan 03, 2015 | WL Toys WLToys V913 Large 4 Channel 27" RC...

1 Answer

Helicopter not working


is the crystal bad in the remote. replace all batteries. move to a different area, you may be getting interference from a wireless gadget

Apr 09, 2014 | Night Hunter Xtreme Glow In The Dark RC...

1 Answer

Stunt copter won't sync


I presume you have lights & sound on the controller when you turn it on - fourteen quick beeps and then a different toned fifteenth beep. The screen lights (blue). Insert the battery (lettering facing up toward the helo fuselage unitl it's seated all the way - an LED inside the fuselage, visible from behind, quick flashes and then begins a slower blinking.

Once the helo battery is inserted, turn on the controller, which starts the aforementioned beeping. On the last controller beep the helo's LED will stay lighted, indicating the helo & controller are synched.

I had a problem making sure the battery was inserted all the way into the helicopter. You'll know it's inserted properly when the LED inside the helo flashes.

Dec 26, 2012 | Brookstone Stunt Copter RC Helicopter

1 Answer

Syma S032 Transmitter battery lights blinks even when Brand new Alkaine Batteries are fitted


0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
This should get you flying. Let me know
r

Jul 30, 2011 | SYMA Toys industrial Syma S032 Ready to...

1 Answer

X107 Mini helicopter does not seem to be taking a charge from USB port on computer. ran coptor for about 2 weeks following recharging instructions... rest, recharge of heli in "off"...


Hi, My X107 MINI HELICOPTER does not receive transmit anymore. It was working fine before. It only flys if I hold the remote control right next to the sensor. If I move it away it loses transmit. Both units have full power. How do I solve this problem.

Jan 27, 2011 | Cobra Electronics Cobra RC 3 Channel Mini...

1 Answer

The helicopter syma s032 not fly, noy function, not syncronize with the remote control. This charging for 90 minutes and the battery of the remote control is new. The helicopter light led is good, to...


0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
This should get you flying. Let me know.

hope this helps,
r

Dec 28, 2010 | SYMA Toys industrial Syma S032 Ready to...

2 Answers

I dont know what band my helicopter is on


I'd use band A and it always works, except that it makes my ihome turn on, switch modes and radio stations, so I use band c. To connect to the heli, turn the helicopter on, wait for a red light to blink inside, then throttle up and down on your remote. Then, your all set. Just do some preflight checks and have fun!

Dec 25, 2010 | Team International Hawk Talon V3 RC Indoor...

Not finding what you are looking for?
Toys Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

15641 Answers

Are you a Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...