Power keeps going off when I press start - GE JVM1650 1000 Watts Microwave Oven

H:H 80 on a Miele microwave indicates that the microwave's Keep Warm feature is in use. To end the cycle, open the microwave door or operate a selector or sensor (press a button (not the time display) or turn the selector knob). The keep warm setting runs the microwave for 15 minutes at 80W power starting 2 minutes after any program that used more the 450W of power. You can turn off the Keep Warm feature completely in the microwave settings. To change the setting, touch the menu button (arrow and three horizontal lines). Press OK and turn the selector knob until you see P9. Press OK and then turn the selector knob to change the setting. Press OK to save.

I found this in the manual for one of the Miele microwaves, http://static.appliancesconnection.com/attachments/D1418829486.pdf . on page 30. The section on changing the settings starts on page 40.

I hope this helps.

Cindy Wells

Safety system locking out the start switch. Door not closed, mode and timer not set etc.

i have power and light is on can not press any numbers or start button or any other button.it keeps on peeping steady

There is an battery inside to keep time and settings in case of a power outage.. Check your maual for the battery location.. Unplug the oven,, replace battery and plug it back in..

Have a great day !

See if this describes what's happening:

• Put in time, push start and unit runs for 2 seconds, relay clicks, unit goes off. Cook time on display goes off and clock time comes back. Bad upper interlock switch and charred connector.

If so, see http://www.microwavedisplay.com/safety.txt , http://www.microwavedisplay.com/disassembly.txt and http://www.microwavedisplay.com/doorsw.txt

Otherwise, if the digital programmer circuit / controller does not get a feedback signal from the inverter for a period of 3 seconds, the controller will stop the cook cycle.

That may be a loose connection in the wiring between the inverter, magnetron, and/or control board, or maybe one of those components has failed.

Due to the lethal voltages used and produced in inverters, I do not recommend that an inexperienced person work on these.

You can find many Panasonic owner's manuals for free download here.

You can find an authorized Panasonic servicer here.

In Canada, you can find an authorized Panasonic servicer here.

If you're not in the US, see Panasonic.net.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Ours just started doing this exact same thing this past Friday - 12/11/09. What's going on? The cook power just starts beeping all by itself and going from 10 down to 1 over and over again. It may stop momentarily, but then starts again within a minute or so - it's constant until we unplug it. We plug it back in and within a few minutes it starts doing it again. What gives?

Could be a blown fuse in the HV transformer primary circuit,bad connections to the magnetron filament,open thermal protector or thermal fuse,

Try pressing and holding the Stop/Clear button until the L disappears and a beep is heard. It appears the child lock is on.: Go to this website for the user manual:
http://safemanuals.com/user-guide-instructions-owner-manual/LG/MS2647GR-_E

when you press for the time you want does it come up on yhe display?? if not clean the circuit board with wd40, & retry dont go two fast when operating as this can lead to the machine not to respond. also check the pad give it a clean and a good dry,

Press "Clock", type in the time on the keypad and then press "Start". The clock runs a little slow (at least on mine) and I have to reset it about once a month. It gets about 10 - 15 minutes behind after awhile.