Question about Panasonic Shiatsu Massage Lounger with Electric Reclining Ep790k

Open Question

When turned on there is a "clunk-clunk-clunk" noise and the lights flashProblem with Reg# PA-24913 Panasonic massage lounger chair

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Instruction manuel for massage lounger panasonic ep 1260

Hi, Went to Google and instruction manuals. From there, I made the proper selection.

Posted on Jan 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need power cord for shiatsu model 8173


where can I find a cord for my shiatsu recliner, model #8173, thank you

Oct 10, 2013 | Panasonic Shiatsu Massage Lounger with...

1 Answer

When was the first vibrating chair made?


Massage chairs were first brought to market in 1962 by the Family Inada company. Today, Japan is the largest consumer of massage chairs with some surveys suggesting that over 20% of Japanese households actually own a massage chair. By comparison, massage chair penetration in the US market is estimated to be in the neighborhood of 1%. The current massage chair market is dominated at the top by a three dominant manufacturers: Fujiiryoki, Family Inada, and Panasonic. After the purchase of Sanyo by Panasonic, Panasonic announced plans to eliminate Sanyo as a brand for all current Sanyo consumer products.

Dec 25, 2012 | Furniture

1 Answer

What are the disadvantages of electric massage chairs?


Electric massage chairs have some disadvantages:
  • They are very expensive- cost at least $1,000, but usually much more.
  • They are very heavy, so they are quite difficult to move around.
  • Because it reduces blood pressure, it is not advised for people with low blood pressure to use these chairs.
  • Some chairs can only hold a certain amount of weight.
  • They are not as effective as getting a massage by a therapist.

Sep 09, 2012 | Panasonic Furniture

1 Answer

Massage starts then stops after 10 seconds


I suggest that you contact Panasonic directly and ask them how you could fix this. Also, you can get in touch with the store you got it from and possibly ask for a new massage chair.
Here's Panasonic contact page: http://shop.panasonic.com/support/

Aug 29, 2012 | Panasonic Real Pro Ultra Massage Chair...

2 Answers

THE MODEL IS EP578.ROLLERS DONT MOVE BUT MOTOR IS FUNCTIONING.LIGHTS IN THE REMOTE ARE BLINKING ALL TOGETHER THEN THE MACHINE STOPS.


I found with my Panasonic EP578 that, if the lower photo sensor limit switch gets too dusty, the massage mechanism will travel downwards past the normal range of motion and the electronics will time out because the unit did not get a down limit sensor signal & reverse direction and proceed back to the upper limit switch in time. With the device unplugged, I simply removed the grommet screws and opened the fabric backing. Then I removed the units cover and Then blew out dusty photo sensors with compressed air. Then I swapped the red and green, 2-pin mag clutch coil connector plugs so that when I switched the unit on again I could make the unit travel back up to about, the scapular position. The reason that this is possible is that when you first start a normally working machine, the first thing that happens after the motor turns on, is that the motor clutch for the mechanism that provides the neck and vertebral massage balls, also energizes. I figured that I could get the voltage at that connector to energize the rolling clutch to get the unit back up again (as you can't move it by hand). Then I turned the unit off (while stile in cycle) and the swapped the mag-clutch coil connectors back to their original position. Re-starting the machine causes the moving massage mechanism to go through it's Power On Routine which realigns everything to it's 'Home' position and ready to run a fully functioning cycle. Remember to unplug the machine when working on it and keep all fingers, necktie, hair, jewelry from moving mechanism when it's moving to avoid damage to the machine and bodily harm to yourself!
P S here's a link to a service manual .pdf download for the Panasonic EP578:

https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&uact=8&ved=0ahUKEwj_zpzD_NvQAhVpqFQKHb6EBbgQFggeMAA&url=http%3A%2F%2Fblog.lincomatic.com%2Fwp-content%2Fuploads%2F2013%2F01%2FEP578.pdf&usg=AFQjCNESCMv3PGtxbXCJfn-RHnEBwiQoIQ&sig2=2t3ZqNxLVT8Y4RJ6nKolmA

Mar 21, 2011 | Panasonic Shiatsu Massage Lounger with...

1 Answer

Finding KSI owner


I found the guy by basically google it.

Sep 18, 2009 | Panasonic Shiatsu Massage Lounger with...

1 Answer

Instruction manuel for massage lounger panasonic ep 1260


Hi, Went to Google and instruction manuals. From there, I made the proper selection.

Jan 30, 2009 | Panasonic Shiatsu Massage Lounger with...

Not finding what you are looking for?
Panasonic Shiatsu Massage Lounger with Electric Reclining Ep790k Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Furniture Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Panasonic Furniture Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...